Instrukcja obsługi Atdec SD-DO

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Atdec SD-DO (2 stron) w kategorii Wsparcie dla płaskich paneli. Ta instrukcja była pomocna dla 21 osób i została oceniona przez 9 użytkowników na średnio 4.0 gwiazdek

Component Checklist

Installation Instructions

A. Use this configuration with a

standard 50mm pole

(No inserts required)

B. Use this configuration with a

Visidec 42mm extrusion

pole

C.

Use this configuration with a

standard 42mm pole

Step 1. Install Quickshift Donut

42mm Front

Donut Insert (x1)

Visidec Groove

Lock (x1)

42mm Rear

Donut Insert (x1)

5mm Allen

Key (x1)

Hardware Mounting

Screws

M4x10mm

Screw (x4)

M4x12mm

Screw (x4)

M4x16mm

Screw (x4)

Select your correct product configuration: A, B, or C.

Rear Donut

Insert

Rear Donut

Insert

Front Donut

Insert Front Donut

Insert

Groove

Insert

Check you have received all parts against this Component Checklist prior to installation.

Tightening

Tool (x1)

2mm Allen

Key (x1)

Slide the Quickshift Donut onto the pole

(with the lever open), removing the End

Cap if necessary.

Rear groove insert must align with slot in

the Pole.

(Visidec 42mm pole shown)

TIGHTEN

LOOSEN

Once in place, close the lever

to lock the Quickshift Donut

in the desired position.

Slide the Quickshift Donut into the desired position.

If necessary, adjust the tension between the

Quickshift Donut and the Pole using the 5mm Allen

Key supplied.

Slot

OR OR

Groove

Insert

Security

Screw (x1)

CLOSE

WARNING: Be careful not to overtighten

! The Spacedec Display Quickshift Donut is to be used on 42mm and 50mm diameter poles only.

! The Manufacturer accepts no responsibility for incorrect installation.

Display | Quickshift Donut

Quickshift

Donut (x1)

Note: Ensure inserts are fitted

in correct orientation.

Arrows point

to top surface

SD-DO

Specyfikacje produktu