Instrukcja obsługi Audio Pro Addon T3

Audio Pro głośnik Addon T3

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Audio Pro Addon T3 (4 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 36 osób i została oceniona przez 18.5 użytkowników na średnio 4.9 gwiazdek

Pobierz PDF

Strona 1/4

KONTROLLER | CONTROLS | SCHALTTAFEL

BYTA BATTERI | CHANGE BATTERY | BATTERIE WECHSELN

FÖRE ANVÄNDANDE | BEFORE USING | VOR DER VERWENDUNG

BAKSIDA | REAR VIEW | RÜCKSEITE

PARA | PAIR | KOPPELN

På/Av (tryck 2 sek)

On/Off (2 sec push)

Ein/Aus (drücken 2 sek)

Batteriindikator

Battery indicator

Batterieanzeige

Laddar

Charging

Laden

100% >25%50%

Para Bluetooth

Pair Bluetooth

Koppeln Bluetooth

Blinkar

Flashes

Blinken

Inställningar

Settings

Einstellungen

USB

Charging only!

Välj ljudkälla

Select source

Quelle auswählen

Använd endast Audio Pro original batteri!

Only use Audio Pro original battery!

Verwenden Sie nur Audio Pro Original-Akku!

Volymkontroll

Volume control

Lautstärkeregelung

1. 2.

5-20s

Page 1-2:

SE: Snabbstartsguide

EN: Quick Start Guide

DE: Schnellstart-Anleitung

Page 3-4:

FR: Guide de demarrage rapide

ES: Guía de inicio rápido

IT: Guida di avvio rapido

FI: Pikaopas

AUX USB

POWER

MAX 5V, 1000mA AC 100-240V 50-60Hz, 40W

AUDIO PRO T3

Alla rättigheter reserverade. Audio Pro följer en policy om ständig produktutveckling. Speciﬁkationer kan ändras utan föregående meddelande.

Ladda batteriet fullt innan du

använder högtalaren första gången.

Charge the battery fully

before using the speaker ﬁrst time.

Laden Sie den Akku vollständig, bevor

Sie Lautsprecher ersten Mal verwenden.

FCC

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1 - THIS DEVICE MAY

NOT CAUSE HARMFUL INTERFERENCE. 2 - THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE

UNDESIRED OPERATION.

MODEL: T3. FCC ID: 2AGNC - T3

FCC WARNING

Any Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This

device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.This equipment complies with FCC radiation

exposure limits set forth for an uncontrolled environment.Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

ADDON T3