Instrukcja obsługi Axton ATW16

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Axton ATW16 (1 stron) w kategorii subwoofer. Ta instrukcja była pomocna dla 24 osób i została oceniona przez 7 użytkowników na średnio 4.3 gwiazdek

INSTALLATION & OPERATION MANUAL /

EINBAU- & BEDIENUNGSANLEITUNG

ATW16 ATW20 ISUBWOOFERS

Thank you and congratulations! You have purchased one of the nest subwoofers available in its respec tive price class. This AXTON

ATW subwoofer will give you great bass performance and true audiophile sound quality. To maximize the performance of your sub,

it is recommended to follow the enclos ure suggestions given in this manual. lf for some reason, the provided system/enclosure data

can not be applied within your specic vehicle or car audio installation, please contact your authorized AXTON dealer to ask for

further assistance.

LIMITED WARRANTY

AXTON warrants any ATW woofer to be free of defects in material and workmanship for a period of TWO YEARS from the original

date of purchase at retail, contingent upon installation being performed or ap proved by an authorized AXTON dealer. Should ser-

vice be necessary during the afore mentioned period, AXTON will at its own discretion repair or replace the defective speaker at

no charge. Damage caused by the following is NOT covered under warranty: Abuse of speaker due to excessive amplier power,

clipping, inappropriate enclosure design, or any further physical damage (during transportation).

CABINET CONSTRUCTION & DAMPING

For best results, use 19 mm to 22 mm MDF or birch plywood

to build the enclosure. All enclos ure volumes given are precise

internal chamber volumes, where displacement of driver and

port(s) have been included already.

Each enclosure, no matter what tuning prin ciple, needs internal

damping: The sealed and ported cabinets should be lined out

internally with "eggcrate" PU-foam.

KEY FEATURES ATW WOOFERS

6.5" / 8"BACK VENTED STEEL BASKET

120 MM HIGH EFFICIENT SINGLE MAGNET

HIGH STRENGTH FIBERGLASS/FOAM/PAPER CONE

LONG-THROW CONEX™ SPIDER

LONG-LASTING RUBBER SURROUND

TSL VOICE-COIL FORMER

1.5” COPPER WIRE DOUBLE VOICE COIL

HYPER-EXTENDED CENTER POLE

WOVEN TINSEL WIRES

RUBBER MAGNET BOOT

GOLD PLATED TERMINAL

Exclusive Distributor for Europe: ACR AG ∙ Bohrturmweg 1 ∙ CH-5330 Bad Zurzach ∙ Switzerland

EU Legal Representative:

ACR S & V GmbH ∙ Industriestr. 35 ∙ D-79787 Lauchringen ∙ GermanyRev. A

TECHNICAL SPECIFICATIONSATW16ATW20

Usable Frequency Response65 ‒ 400 Hz55 ‒ 300 Hz

Continuous Power Handling 75W RMS75W RMS

Peak Power Handling150W max150W max

Nominal lmpedance2 x 2ohms2 x 2ohms

Voice Coil Diameter38mm38mm

Sensitivity84 86.7dB dB

Mounting Diameter145mm184mm

Mounting Depth79mm80mm

THIELE-SMALL PARAMETERS

Free-Air Resonance(Fs)47.1Hz36.34Hz

DC Resistance(Re)4.5ohms4.4ohms

Electrical Damping(Oes)0.630.35

Mechanical Damping(Qms)6.237.98

Total Damping(Ots)0.340.33

Equivalent Volume of Compliance(Vas)7.1521.49liter liter

Moving Mass incl. Air Load(Mms)42.457.86g g

Electrically Limited Cone Excursion(Xmax p-p)6.7mm6.7mm

Effective Cone Surface(Sd)136.8cm²213.8cm²

RECOMMENDED ENCLOSURES

SEALED ENCLOSURE

Internal Volume1015l l

PORTED ENCLOSURE

Internal Volume1820l l

Port Diameter/Length1 x 7 cm ‒ 20 cm1 x 7 cm ‒ 25 cm

Specyfikacje produktu