Instrukcja obsługi Bauknecht GSF 6930
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Bauknecht GSF 6930 (8 stron) w kategorii zmywarka. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 9.5 użytkowników na średnio 4.6 gwiazdek
Strona 1/8
GB -1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
(see at right for options description)
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute (0:01
is shown into the display).
If pressed when the dishwasher is switched off, it
drains any possible liquids from dishwasher
(1minute process).
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional
options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the
appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.
Table of programs
Deter-
gent
Consumption
PPrograms Available
options Loading instructions Litres kWh Minutes 1)
1Sensor 40-70°C Delay
Multizone
Power Clean
Normally or heavily soiled crockery,
including pots and pans. None soaking
or hand pretreatment is needed. In
addition hygiene of the complete
loading is ensured with this program.
X 7-14 1.00-1.80 70-185
2Pre-Wash cold Delay
Multizone Crockery to be washed later. — 4.0 0.03 14
3Glasses 40°C Delay
Multizone
Light soiling, for example glasses and
cups. X 10.0 0.85 100
4Quickwash 45°C Delay
Multizone
Lightly soiled crockery, with no
dried-on food. X 11.0 0.80 30
5Bio Normal 2) 50°C Delay
Multizone
Power Clean
Normally soiled crockery. X 12.0 1.05 150
6Daily 60°C Delay
Multizone Normally to heavily soiled crockery. X 13.0 1.25 120
5019 496 01671
GSF 6930 PC
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates
the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.
MULTIZONE
Allows you to choose the washing
zones. Press this button (repeatedly)
to select the wash zones:
both racks
only lower rack
only upper rack
- indicator lits
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up) if
you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after 24
restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
POWER CLEAN
Thanks to the additional power jets
this option provides a more intensive
and powerful wash in the lower rack,
in the specific area. This option is
recommended for washing pots and
casseroles (see page 4). Press this
button to activate Power Clean (the
indicator lights up).
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide
Specyfikacje produktu
| Marka: | Bauknecht |
| Kategoria: | zmywarka |
| Model: | GSF 6930 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Bauknecht GSF 6930, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje zmywarka Bauknecht
21 Września 2024
21 Września 2024
3 Sierpnia 2024
3 Sierpnia 2024
3 Sierpnia 2024
3 Sierpnia 2024
3 Sierpnia 2024
2 Sierpnia 2024
2 Sierpnia 2024
2 Sierpnia 2024
Instrukcje zmywarka
- Candy
- Cylinda
- Blomberg
- Insignia
- Thermador
- Comfee
- Bomann
- BLANCO
- Grundig
- Beko
- Respekta
- AEG-Electrolux
- Artusi
- GE
- Ariston Thermo
Najnowsze instrukcje dla zmywarka
28 Października 2024
28 Października 2024
28 Października 2024
23 Października 2024
21 Października 2024
21 Października 2024
12 Października 2024
12 Października 2024
12 Października 2024
12 Października 2024