Instrukcja obsługi Electro-Voice EVA-1151D


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Electro-Voice EVA-1151D (2 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 19 osób i została oceniona przez 10 użytkowników na średnio 4.3 gwiazdek

Strona 1/2
EVA-AM
Attenuation Module
for EVA Loudspeakers
Installation Instructions
Tools Required:
1. Remove the input panel by removing the eight screws securing it.
2. Carefully unplug the crossover cable from the 10-pin header.
3. Unplug and discard the 7-pin jumper connector at the far end of the circuit board.
Instructions:
1. #2 Phillips Screwdriver 2. 3/16” (5mm) Flat Blade Screwdriver
3/16”
[5mm]
#2
4. With the green circuit board on the
right, place the attenuation module
in the pocket provided for it on the
left with the lead wires from the
module pointing toward you.
5. Secure the EVA-AM mounting ears
to the four input panel bosses
with the four #10 screws provided.
Carefully tighten the screws evenly
in an X-cross pattern to avoid
warping the plastic input panel.
6. Plug in the 7-pin wiring harness
connector from the attenuation
module where the 7-pin jumper
was removed in step 3.
Figure 1:
Remove panel, unplug
crossover cable and jumper
Figure 2:
Attach module and plug in
7-pin module connector
7-pin
10-pin


Specyfikacje produktu

Marka: Electro-Voice
Kategoria: głośnik
Model: EVA-1151D

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Electro-Voice EVA-1151D, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą