Instrukcja obsługi Extron DA4 RGBHV
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Extron DA4 RGBHV (1 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 29 osób i została oceniona przez 15 użytkowników na średnio 4.5 gwiazdek
Strona 1/1
Setup Guide — DA RGB/YUV Series
This card provides quick start instructions for an experienced
installer to set up and operate an Extron DA2/4/6 RGB
or DA 6 YUV A distribution amplifier.
N
The DA RGBHV models buffer and distribute
RGBHV, RGBS, RGsB, and RsGsBs video.
The buffers and distributes DA6 YUV A
component video and digital audio. The DA
can also buffer and distribute RGBS, RGsB,
and RsGsBs video. By using the digital audio connections for composite sync rather than
audio, the DA can distribute RGBS video.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the transmitter and receiver
as required.
Use an optional RSU 129 1U Rack Shelf for rack mounting.DA2 RGBHV —
Use an optional MBU 125 Under-Desk Mount Kit to mount the DA under
furniture.
Use an optional MBD 129 Thru-Desk Mount Kit to mount the DA through
furniture.
Use the included rack mounting bracket for rack or through-desk mounting.All other DAs —
Use an optional MBU 149 1U Enclosure Under-Desk Mount Kit to mount
the DA under furniture.
Step 2 — Video input (all models)
Connect the RGB or component video input as shown. You can connect RGsB or RsGsBs
video to a DA6 YUV A. You can also connect RGBS video to a DA6 YUV A by connecting the
composite sync (S) input to the digital audio input BNC.
RGsB,
RsGsBs
(or component
video)
Component
video (or
RGBS, RGsB,
RsGsBs
DA6 YUV A
RGBHV
video
RGBS
video
R
H
H/V
G
V
B
R
H
H/V
G
V
B
R
H
H/V
G
V
B
Y
DA2 / 4 / 6 RGBHV
DA6 YUV ADA2 / 4 / 6 RGBHV
R-Y
B-Y
DIGITAL
AUDIO
Step 3 — Digital audio input (DA6 YUV A only)
Connect a digital audio source to the input Digital Audio connector.
DIGITAL
AUDIO
If you are using the DA to buffer RGBS video, connect the composite sync (S)
input to this connector in place of the digital audio.
Setup Guide — DA RGB/YUV Series, cont’d
68-512-50
Rev. A 01 10
Step 4 — Video outputs
(all models)
Connect RGB or component video
displays or other devices as shown.
Make connections as shown at right.
You can use a DA6 YUV A to buffer
RGsB or RsGsBs video. You can also
output RGBS video by connecting
the composite sync (S) plane on the
digital audio BNC to the composite
sync (S) input of the video displays
or other devices.
Step 5 — Digital audio
outputs (DA6 YUV A only)
Connect digital audio devices to the output Digital Audio connectors. If you
are using the DA to buffer RGBS video, connect this BNC to the composite
sync (S) input of the video displays or other devices.
Step 6 — Mute connector (all, excluding DA6 YUV A)
Each active pin of the 9-pin D
connector is assigned to one
output of the DA (pin 2 is
assigned to all DA outputs).
Short and latch an active pin
to ground to mute the R, G,
and B video planes of that
output.
Step 7 — DIP switches
The DAs have two rear panel DIP switches; one to turn gain and peaking
AC/DCGAIN/PEAK
ON
on and off (Spare on the DA6 YUV A) and one to turn AC coupling on and off.
Gain/Peak (RGB units only) — On (up) applies gain and peaking. Use this
position for long cable runs (up to 200 feet using Extron MHR cable). Off
(down) turns off gain or peaking. Use this position for short cable runs.
AC/DC switch — On (up) when the signal source has a high DC offset. Off (down) is the
default position for the best picture quality.
Step 8 — Power
Plug in a standard IEC power cord from a 100 to 240 VAC, 50 - 60 Hz power source into this
receptacle.
Operation
After all devices are powered up, the system is fully operational. If any problems are
encountered, verify that the cables are routed and connected properly and that all display
devices have identical resolutions and refresh rates. If your problems persist, call the Extron
S
3
Sales & Technical Support Hotline at the number shown below closest to you.
Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
© 2010 Extron Electronics. All rights reserved.
Pin Contact closure Function
1 Out #1 Mute output #1
2
—
Out all Mute all outputs
3 Not used
4 Out #2 Mute output #2
5 Gnd Ground
6 Out #3
Out #4
Out #5
Out #6
Mute output #3
Mute output #6
Mute output #4
Mute output #5
7
8
9
Female
5 1
9 6
Male
1 5
6 9
RGBHV
video
RGBS
video
RGsB,
RsGsBs
(or component
video)
Component
video (or
RGBS, RGsB,
RsGsBs
DA6 YUV A
DA2 RGBHV, DA4 RGBHV, DA6 RGBHV
H
H/V
V
R
G
B
H
H/V
V
R
G
B
H
H/V
V
R
G
B
DIGITAL
AUDIO
Y
R-Y
B-Y
DIGITAL
AUDIO
Specyfikacje produktu
| Marka: | Extron |
| Kategoria: | odbiornik |
| Model: | DA4 RGBHV |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Extron DA4 RGBHV, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje odbiornik Extron
10 Marca 2025
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
Instrukcje odbiornik
- PAC
- Mobile Crossing
- Crest
- Denon
- Dynacord
- Streacom
- Karma
- Redline
- Epcom
- Comtek
- JL Audio
- Unison Research
- Revel
- Zoom
- Homematic IP
Najnowsze instrukcje dla odbiornik
9 Kwietnia 2025
9 Kwietnia 2025
5 Kwietnia 2025
4 Kwietnia 2025
3 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
1 Kwietnia 2025
30 Marca 2025
30 Marca 2025