Instrukcja obsługi Focal FDP Sport V2
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Focal FDP Sport V2 (12 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5.5 użytkowników na średnio 4.3 gwiazdek
Strona 1/12
1
Shared Controls
(All Channels)
Ch 1+2 Controls Refer to Figures 2B, 3B, or 4B for wiring diagrams
Refer to Figures 2A, 3A, or 4A for control diagramsCh 3+4 Controls
Figure 1 | N
CONFIGURATIONS
These are the 3 basic configurations that you will be using when installing your Focal FDP
SPORT V2. Pick the mode you will be running, turn to the appropriate page, and follow the
instructions to make the correct amp adjustments.
• 4 Channel Stereo Mode (Page 2)
• 2 Channel Bridged Stereo Mode (Page 4)
• 3 Channel Stereo and Bridged Mono Mode (Page 6)
FDP SPORT V2: 4-CH MOTO & ALL-TERRAIN AMP
OPERATION / CONFIGURATION MANUAL
FDP SPORT
V2
avigating the FDP Sport V2 Controls
2
4 CHANNEL STEREO MODE
INPUTS
• Under the “INPUTS”, move the switch to either position of “2IN or 4IN” depending on how many
inputs you are using to run the amp, 2 or 4.
• If you are only using one single pair of RCA’s from your source, then plug them into the Channel 3+4
or (REAR) RCA inputs, and select “2IN”
• If you are using the Harley Molex harness, then you are setting the switch to “2IN”
NOTE: RCA HARNESSFOR 2 CHANNEL INPUT USING THE (CH 1 & 2 INPUTS)
OR THE WITHOUT FACTORY REAR SPEAKERS:HARLEY HARNESS
You will need to use the patch harness. Set switch to and use input Channels 3 & 4 4 inch 2 IN
NORMAL/BRIDGED
• This switch should be set to “NORM”
SLOPE
• You can select the crossover slope you want for both channels, either a 6db/octave slope or a 12db/
octave slope.
• 12 db/octave is a sharper roll off slope, where the 6db/octave is more gradual roll off slope.
CHANNELS 1 & 2 CROSSOVER CONFIGURATION
• Channels 1+2 can be run in either Full Range, or in High Pass (HP) mode, using the bottom
row of controls. To run in Full Range mode, adjust the HP control down to the 10hz position.
• To run in HP mode, adjust the HP control to your desired HP frequency.
• Motorcycles normally use HP 120Hz.
CHANNELS 3 & 4 CROSSOVER CONFIGURATION
• You can select between Full Range (FR), Low Pass (LP), High Pass (HP), or Band Pass (BP) mode,
using the top row of controls.
• For FR, set MODE switch to HP, and adjust the HP control down to 10hz.
• For HP, set the MODE switch to HP, and adjust the HP control to set the HP frequency.
• For LP, set the MODE switch to LP. Adjust the HP control down to 10hz. Then adjust LP control to set
the LP frequency.
• For BP, set the MODE switch to LP, and adjust the LP control to the desired LP frequency. Adjust the
HP control to set HP frequency.
• Motorcycles normally use HP 120Hz.
GAIN CONTROL
• In this mode you will be using both gain controls to match your sources output level to your
amplifiers input.
SPEAKER OUTPUTS
• Following the wiring diagram in Figure 2B, wire your speakers to the appropriate output wires,
respecting the channels, and the + and – phasing.
3
Select “ ” Front Channel 1+2 ANORM djustments
Select the amount of inputs you are using
Rear Channel 3+4 Adjustments
FRONT SPEAKERS
+ – + –
REAR SPEAKERS
+ – + –
BATTERY
50 AMP FUSE
GROUND
AMP TURN ON
LEFT
Ch. 1
RIGHT
Ch. 2
LEFT
Ch. 3
RIGHT
Ch. 4
Figure 2B | 4 Channel Stereo Mode Wiring Diag mra
FDP SPORT
V2
FDP SPORT V2
Specyfikacje produktu
| Marka: | Focal |
| Kategoria: | odbiornik |
| Model: | FDP Sport V2 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Focal FDP Sport V2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje odbiornik Focal
29 Września 2024
22 Września 2024
22 Września 2024
22 Września 2024
22 Września 2024
22 Września 2024
22 Września 2024
21 Września 2024
21 Września 2024
21 Września 2024
Instrukcje odbiornik
- odbiornik Mtx Audio
- odbiornik HQ
- odbiornik Harman Kardon
- odbiornik JBL
- odbiornik Salora
- odbiornik Amiko
- odbiornik Alto
- odbiornik Valcom
- odbiornik Crest Audio
- odbiornik Morel
- odbiornik HQ Power
- odbiornik Music Hall
- odbiornik Helix
- odbiornik Revox
- odbiornik Integra
Najnowsze instrukcje dla odbiornik
9 Kwietnia 2025
9 Kwietnia 2025
5 Kwietnia 2025
4 Kwietnia 2025
3 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
1 Kwietnia 2025
30 Marca 2025
30 Marca 2025