Instrukcja obsługi GE Profile P2S975BEMBB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE Profile P2S975BEMBB (52 stron) w kategorii piekarnik. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 7 użytkowników na średnio 5.0 gwiazdek

TOOLS YOU WILL NEED

• 1/4” Nut Driver• Level• Pipe Wrench

• Tape Measure• Drill•Safety Glasses

• Phillips Head •Flat Head•Wrench or Pliers

ScrewdriverScrewdriver(for 1 7/16” Nut)

1

MATERIALS YOU MAY NEED

31-10641-3 03-09 JR

Printed in the United States

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com

In Canada, call 1.800.561.3344 or Visit our Website at: www.GEAppliances.ca

Installation

Self-Cleaning Dual Fuel

Instructions

Slide-In Range

P2S975

BEFORE YOU BEGIN

Read these instructions completely

and carefully.

•IMPORTANT —Save these

instructions for local inspector’s use.

•IMPORTANT —Observe all

governing codes and ordinances.

•Note to Installer – Be sure to leave these

instructions with the Consumer.

•Note to Consumer – Keep these

instructions for future reference.

•Product failure due to improper installation

is not covered under the Warranty.

WARNING —This appliance must

be properly grounded.

•Proper installation is the responsibility

of the installer and product failure due

to improper installation is NOT covered

under warranty.

WARNING —

Before beginning

the installation, switch power off at service

panel and lock the service disconnecting means

to prevent power from being switched on

accidentally. When the service disconnecting

means cannot be locked, securely fasten

a prominent warning device, such as a tag,

to the service panel.

IN THE COMMONWEALTH OF

MASSACHUSETTS:

• This product must be installed by

a licensed plumber or gas fitter.

• When using ball-type gas shut-off valves,

they shall be the T-handle type.

• A flexible gas connector, when used,

must not exceed 3 feet.

PARTS INCLUDED

Anchor SleevesLag Bolts

(For Concrete Floors Only)

Shut Off ValvePipe Fittings

CSA-Approved Flexible Gas Line

3/8″Min. ID, 1/2″NPT Connection,

3-foot Maximum Length (Massachusetts only)

Joint Sealant

Screws

Rear Filler

2 Screws

FOR YOUR SAFETY

If you did not receive an anti-tip bracket with your

purchase, call 1.800.626.8774 to receive one at no cost.

(In Canada, call 1.800.561.3344.)

For installation instructions of the bracket, visit:

GEAppliances.com. (In Canada, www.GEAppliances.ca.)

Anti-Tip Bracket

Kit Included

Specyfikacje produktu