Instrukcja obsługi GE Profile PTD70EBPTDG
GE
Suszarka bębnowa
Profile PTD70EBPTDG
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE Profile PTD70EBPTDG (68 stron) w kategorii Suszarka bębnowa. Ta instrukcja była pomocna dla 13 osób i została oceniona przez 7 użytkowników na średnio 4.8 gwiazdek
Strona 1/68
Installation
Dryer
Instructions
If you have any questions, call GE Appliances at 800.GE.CARES
(800.432.2737) or GEAppliances.com visit our Website at:
In Canada, call 800.561.3344 or visit www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT – Save these instructions for
local electrical inspector’s use.
• IMPORTANT – Observe all governing
codes and ordinances.
• Install the clothes dryer according to the
manufacturer’s instructions and local codes.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Clothes dryer installation must be performed by a
qualified installer.
• This dryer must be exhausted to the outdoors.
• Before the old dryer is removed from service or
discarded, remove the dryer door.
• Service information and the wiring diagram are
located in the control console.
• Do not allow children on or in the appliance. Close
supervision of children is necessary when the
appliance is used near children.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• Install the dryer where the temperature is above
50°F for satisfactory operation of the dryer control
system.
• Remove and discard existing plastic or metal foil
duct and replace with UL-listed duct.
- Risk of Fire
• Clothes dryer installation must be performed by a
qualified installer.
• Install the clothes dryer according to these
instructions and local codes.
• DO NOT install a clothes dryer with flexible plastic
venting materials. If flexible metal (semi-rigid or
foil-type) duct is installed, it must be UL-listed and
installed in accordance with the instructions found
in “Connecting the Dryer to House Vent” later in
this manual. Flexible venting materials are known
to collapse, be easily crushed and trap lint. These
conditions will obstruct dryer airflow and increase
the risk of fire.
• DO NOT install or store this appliance in any
location where it could be exposed to water or
weather.
• To reduce the risk of severe injury or death, follow
all installation instructions.
• Save these instructions. (Installers: Be sure to
leave these instructions with the customer.)
WARNING
In the Commonwealth of Massachusetts,
the following installation instructions apply:
• Installation must be performed by a qualified or
licensed contractor, plumber, or gasfitter qualified
or licensed by the State.
• If using a ball valve, it shall be a T-handle type.
• A flexible gas connector, when used, must not
exceed 4 feet (1.2 m).
FOR GAS DRYERS ONLY
12-21 GEA
31-3000245-2
Specyfikacje produktu
| Marka: | GE |
| Kategoria: | Suszarka bębnowa |
| Model: | Profile PTD70EBPTDG |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z GE Profile PTD70EBPTDG, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Suszarka bębnowa GE
1 Marca 2025
31 Stycznia 2025
31 Stycznia 2025
31 Stycznia 2025
31 Stycznia 2025
15 Grudnia 2024
8 Grudnia 2024
8 Grudnia 2024
9 Października 2024
9 Października 2024
Instrukcje Suszarka bębnowa
- Eldom
- PKM
- Hanseatic
- Everglades
- Yamazen
- Royal Sovereign
- Grundig
- Andis
- Simpson
- Juno
- Listo
- Morris
- Heinner
- Koenic
- Fagor
Najnowsze instrukcje dla Suszarka bębnowa
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
8 Kwietnia 2025
7 Kwietnia 2025