Instrukcja obsługi Havis C-3090-4

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Havis C-3090-4 (4 stron) w kategorii zestaw samochodowy. Ta instrukcja była pomocna dla 22 osób i została oceniona przez 3 użytkowników na średnio 4.5 gwiazdek

INSTALLATION INSTRUCTIONS C-3090’s & C-3089’s

COMPUTER LAPTOP MOUNT AND ACCESSORIES

TOOLS NEEDED:

Ratcheting wrench

Standard socket set

Open-end wrench set

Allen wrench set

Screwdriver set

Always!

Read all instructions before installing any Havis, Inc. products.

Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

Use hardware provided with install kit

1.MOUNTING C-3090-3 or 4 & C-3089-3 or 4 to C-TCB’S

Photo #3 on page #2 is a basic assembly

instruction of a C-3090-3 (w/ tilt/swivel)

mounting to a C-TCB-x.

The tilt/swivel assembly, (Photo #1), which

comes pre-assembled to the C-3090 from the

factory, will bolt directly to the rotating plate,

using the hardware loosely attached to the

plate. You do not need to unassembled the

tilt/swivel from the C-3090.

Note: Be sure the 2” fender washer is assembled between

the rotating plate and the tilt/swivel assembly.

2. C-3090-1 or 2 & C-3089-1 or 2 MOUNTING TO

VEHICLE TUNNEL PLATES:

The C-3090 will come pre-assembled with

tilt/swivel attached.

Mount trak kit into vehicle.

Place console and C-3090 into desired

position on trak. (Photo #2)

Note: Be sure assembly does not interfere with dash or

console.

Slide ¼-20 hex nuts into slots on side of trak

in location to mount C-3090.

Attach C-3090 to trak using ¼-20 x ½” hex

bolts and washers. Tighten in desired area.

Photo #1

Photo #2

Specyfikacje produktu