Instrukcja obsługi ICOM IC-F111S
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla ICOM IC-F111S (20 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5.5 użytkowników na średnio 4.8 gwiazdek
Strona 1/20

iF111S
VHF TRANSCEIVER
INSTRUCTION MANUAL
UHF TRANSCEIVER
iF121S
iF211S
iF221S

i
IMPORTANT
EXPLICIT DEFINITIONS
RWARNING! NEVER connect the transceiver to an
AC outlet. This may pose a fire hazard or result in an electric
shock.
CAUTION! NEVER touch the transceiver (especially
the heat sink) when transmitting continuously for long peri-
ods. It will become hot.
NEVER connect the transceiver to a power source of more
than 16 V DC such as a 24 V battery. This connection will ruin
the transceiver.
NEVER cut the DC power cable between the DC plug and
fuse holder. If an incorrect connection is made after cutting,
the transceiver might be damaged.
NEVER place the transceiver where normal operation of
the vehicle may be hindered or where it could cause bodily
injury.
NEVER allow children to touch the transceiver.
NEVER expose the transceiver to rain, snow or any liquids.
PRECAUTION
WORD DEFINITION
RWARNING Personal injury, fire hazard or electric shock
may occur.
CAUTION Equipment damage may occur.
NOTE If disregarded, inconvenience only. No risk
of personal injury, fire or electric shock.
READ ALL INSTRUCTIONS carefully and com-
pletely before using the transceiver.
SAVE THIS INSTRUCTION MANUAL — This
instruction manual contains important operating instructions
for the IC-F111S/F121S VHF TRANSCEIVER and IC-
F211S/F221S UHF TRANSCEIVER.
Icom, Icom Inc. and the logo are registered trademarks of
Icom Incorporated (Japan) in the United states, the United
Kingdom, Germany, France, Spain, Russia and/or other coun-
tries.
SmarTrunk II™ is a Trademark of SmarTrunk Systems, Inc.

ii
USE the supplied microphone only. Other microphones
have different pin assignments and may damage the trans-
ceiver.
DO NOT use or place the transceiver in areas with tempera-
tures below –22°F (–30°C) or above +140°F (+60°C), or in areas
subject to direct sunlight, such as the dashboard of a vehicle.
AVOID operating the transceiver without running the vehi-
cle’s engine. The vehicle’s battery will quickly run out if the
transceiver is in transmission while the vehicle’s engine OFF.
AVOID placing the transceiver in excessively dusty envi-
ronments.
AVOID placing the transceiver against walls. This will
obstruct heat dissipation.
AVOID the use of chemical agents such as benzine or alco-
hol when cleaning, as they damage the transceiver surfaces.
For U.S.A. only
CAUTION: Changes or modifications to this transceiver, not ex-
pressly approved by Icom Inc., could void your authority to operate
this transceiver under FCC regulations.
TABLE OF CONTENTS
IMPORTANT .................................................................................... i
EXPLICIT DEFINITIONS ................................................................. i
PRECAUTION .................................................................................. i
TABLE OF CONTENTS .................................................................. ii
1 PANEL DESCRIPTION ........................................................... 1–5
■Front panel ............................................................................... 1
■Function LED ........................................................................... 2
■Programmable function keys .................................................... 3
2 OPERATION ............................................................................ 6–8
■Turning power ON .................................................................... 6
■Channel selection ..................................................................... 6
■Receiving and transmitting ....................................................... 7
DTransmitting notes ................................................................. 7
DScrambler function ................................................................ 8
DUser set mode ....................................................................... 8
3 CONNECTION AND MAINTENANCE .................................. 9–13
■Rear panel and connection ...................................................... 9
■Supplied Accessories ............................................................. 10
■Mounting the transceiver ......................................................... 11
■Optional UT-108 installation ................................................... 11
■Optional UT-109/UT-110 installation ...................................... 12
■Optional OPC-617 installation................................................. 12
■Antenna................................................................................... 13
■Fuse replacement .................................................................. 13
■Cleaning ................................................................................. 13
4 OPTIONS ................................................................................... 14
5 SAFETY TRAINING INFORMATION ........................................ 15
Specyfikacje produktu
Marka: | ICOM |
Kategoria: | odbiornik |
Model: | IC-F111S |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z ICOM IC-F111S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje odbiornik ICOM
5 Października 2024
5 Października 2024
5 Października 2024
29 Września 2024
28 Września 2024
27 Września 2024
26 Września 2024
22 Września 2024
20 Września 2024
20 Września 2024
Instrukcje odbiornik
- odbiornik Manley
- odbiornik GlobalSat
- odbiornik Bowers & Wilkins
- odbiornik HQ
- odbiornik Cerwin-Vega
- odbiornik ESX
- odbiornik Deaf Bonce
- odbiornik Kopul
- odbiornik SmartSystem
- odbiornik Nedis
- odbiornik Fishman
- odbiornik Edwards Signaling
- odbiornik JL Audio
- odbiornik Advance
- odbiornik Motorola
Najnowsze instrukcje dla odbiornik
9 Kwietnia 2025
9 Kwietnia 2025
5 Kwietnia 2025
4 Kwietnia 2025
3 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
1 Kwietnia 2025
30 Marca 2025
30 Marca 2025