Instrukcja obsługi Indesit IWTE 51251

Indesit pralka IWTE 51251

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Indesit IWTE 51251 (84 stron) w kategorii pralka. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 9.5 użytkowników na średnio 5.0 gwiazdek

Pobierz PDF

Strona 1/84

Contents

Installation, 2-3

Unpacking and levelling

Electric and water connections

The first wash cycle

Technical data

Care and maintenance, 4

Cutting off the water or electricity supply

Cleaning the washing machine

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

How to clean the detergent dispenser

Precautions and tips, 5

General safety

Disposal

Description of the washing machine, 6-7

Control panel

Display

How to open and shut the drum

Running a wash cycle, 8

Wash cycles and options, 9

Table of wash cycles

Wash options

Detergents and laundry, 10

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Load balancing system

Troubleshooting, 11

Service, 12

IWTE 51251

Instructions for use

WASHING MACHINE

English, 1

Nederlands, 37

Italiano, 13

Français, 25

Español,49 Portuguęs,61

ΕΛΛΗΝΙΚΑ,73

Installation

! Keep this instruction manual in a safe place for

future reference. Should the appliance be sold,

transferred or moved, make sure the instruction

manual accompanies the washing machine to

inform the new owner as to its operation and

features.

! Read these instructions carefully: they contain

vital information on installation, use and safety.

Unpacking and levelling

Unpacking

1. Unpack the washing machine.

2. Check whether the washing machine has been

damaged during transport. If this is the case, do

not install it and contact your retailer.

3. Remove the four pro-

tective screws and the

rubber washer with the

respective spacer, si-

tuated on the rear of the

appliance (see figure).

4. Seal the gaps using the

plastic plugs provided.

5. Keep all the parts: you

will need them again if

the washing machine

needs to be moved to

another location.

Warning: should the

screws be re-used,

make sure you fasten

the shorter ones at the top.

! Packaging materials are not children’s toys.

Levelling

1. Install the washing machine on a flat sturdy

floor, without resting it up against walls, furniture

cabinets or other.

2. If the floor is not per-

fectly level, compensate

for any unevenness by

tightening or loosening

the adjustable front feet

(see figure); the angle

of inclination, measu-

red according to the

worktop, must not ex-

ceed 2°.

Levelling your appliance

correctly will provide it with stability and avoid any

vibrations, noise and shifting during operation.

If it is placed on a fitted or loose carpet, adjust

the feet in such a way as to allow enough room

for ventilation beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it to

a cold water tab using

a ¾ gas threaded con-

nection (see figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the other

end of the water inlet

hose to the washing

machine,

screwing it onto the ap-

pliance’s cold water in-

let, situated on the top

right-hand side on the

rear of the appliance

(see figure).

3. Make sure there are no kinks or bends in the

hose.

! The water pressure at the tap must be within

the values indicated in the Technical details

table .(on the next page)

! If the water inlet hose is not long enough,

contact a specialist store or an authorised

serviceman.

! Never use hoses that have already been used.

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drainage duct

or a wall drain located

at a height between

65 and 100 cm from

the floor;

alternatively, rest it on

the side of a washba-

sin or bathtub, faste-

ning the duct sup-

plied to the tap (see

figure). The free end

of the hose should

not be underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose and

must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity

socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the maximum

power load of the appliance as indicated in the

Technical data table (see opposite);

• the power supply voltage falls within the va-

lues indicated in the Technical data table (see

opposite);

• the socket is compatible with the plug of the

washing machine. If this is not the case, repla-

ce the socket or the plug.

! The washing machine must not be installed

outdoors, even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! When the washing machine has been installed,

the electricity socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced

by authorised technicians.

Warning! The company shall not be held respon-

sible in the event that these regulations are not

respected.

The first wash cycle

Once the appliance has been installed, and be-

fore you use it for the first time, run a wash cycle

with detergent and no laundry, setting the 90°C

programme without a pre-wash cycle.

65 - 100 cm

Technical data

Model IWTE 51251

Dimensions

width 40 cm

height 85 cm

depth 60 cm

Capacity from 1 to 5 kg

Electrical

connections

please refer to the technical

data plate fixed to the machine

Water

connection

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 42 litres

Spin speed

up to 1200 rotations per minute

Test wash

cycles in

accordan-

ce with

directives

1061/2010

and

1015/2010

Programme 3:

Cotton standard 60°C.

Programme 4:

Cotton standard 40°C.

This appliance conforms to

the following EC Directives:

- 2004/108/EC dated

03/05/89 (Electromagnetic

Compatibility)

- 2012/19/EU

- 2006/95/EC Low Voltage)

Specyfikacje produktu

Marka:	Indesit
Kategoria:	pralka
Model:	IWTE 51251
Kolor produktu:	Biały
Typ kontroli:	Buttons, Rotary
Wbudowany wyświetlacz:	Tak
Położenie urządzenia:	Wolnostojący
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	220 - 240 V
Wysokość produktu:	850 mm
Szerokość produktu:	400 mm
Głębokość produktu:	600 mm
Waga produktu:	63000 g
Szerokość opakowania:	850 mm
Wysokość opakowania:	950 mm
Głębokość opakowania:	660 mm
Kolor drzwiczek:	Biały
Ilość programów piorących:	16
Technologia przetworników:	Nie
Opóźniony start czasomierza:	Tak
Opóźniony start:	24 h
Pobór wody na cykl:	- l
Wskaźnik pozostałego czasu:	Tak
Klasa efektywności energetycznej (stara):	A+
Pranie zużywające energię:	0.882 kWh
Typ ładowania:	Od góry
Zawias drzwiczek:	W górę
Kategoria prania:	A
Pojemność znamionowa:	5 kg
Maksymalna prędkość obrotu:	1200 RPM
Klasa wirowania (suszenia):	B
Poziom hałasu (pranie):	61 dB
Poziom hałasu (wirowanie):	71 dB
Programy prania:	Hygiene/anti-allergy, Black, Cotton, Eco, Quick, Sport, Delicate/silk
Pojemność bębna:	42 l
Czas cyklu (max):	160 min
Regulowana prędkość obrotów:	Tak
Roczne zużycie energii pranie:	169 kWh
Roczne zużycie wody pranie:	8511 l
Waga wraz z opakowaniem:	64500 g
Minimalna prędkość obrotu:	1400 RPM
funkcja Rinse Plus:	Tak