Instrukcja obsługi La Crosse Technology 31300
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla La Crosse Technology 31300 (1 stron) w kategorii Radiobudzik. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 7.5 użytkowników na średnio 4.8 gwiazdek
Strona 1/1
Two Year Limited Warranty (U.S.A.)
Equity products are warranted for two years from the date of consumer purchase
against defects in material and workmanship. During this period such defects will be
repaired, or the product will be replaced at Equity’s option, without charge. This
warranty does not cover damage caused by misuse or negligence. ALL IMPLIED WAR-
RANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OR FITNESS AND
MERCHANTABILITY, ARE LIMITED IN DURATION T0 A PERIOD ENDING TWO YEARS FROM
DATE OF PURCHASE . Some states do not allow limitations on how long an implied
warranty lasts so the above limitation may not apply to you. This warranty gives you
specific legal rights and you may also have other rights which vary from State to State.
If your product is not working properly, please send:
- the product
- a letter explaining the problem
- and $5.00 for postage and handling to :
Equity by La Crosse
Warranty Department
2830 26th St. S.
La Crosse, WI 54601
Made in China
Printed in China
Please read this before operating your clock
LCD TRAVEL ALARM CLOCK
Model 31300
FCC INFORMATION:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions,
may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment o and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment
Battery Installation
* The battery compartment is located on the bottom of the clock. Remove the battery cover
and insert two “AAA” batteries according to the polarity indication inside the battery
compartment. Replace the battery cover. (Batteries not included)
Plesae help in preservation of the environment and return used batteries to an authorized depot.
Remove the battery from the clock if you do not intend to use for an extended period of time.
SNOOZE / AL ON / AL OFF Set Switch
NAP Indicator
Setting The Time
* Slide the LOCK / AL / TIME / CAL TIME set switch to position.
* Press button to set the correct hour. The PM indicator will light HOUR / MONTH
when the hour is advanced into the PM time.
* Press MIN / DATE button to set the correct minute.
* Slide the LOCK / AL / TIME / CAL LOCK set switch to after set your time.
Setting The Alarm Time
* Slide the LOCK / AL / TIME / CAL ALset switch to position.
* Press button to set the correct hour. The PM indicator will lightHOUR / MONTH
when the hour is advanced into the PM time.
* Press MIN / DATE button to set the correct minute.
* Slide the LOCK / AL / TIME / CAL LOCK set switch to after set your alarm time.
Setting The Calendar
* Slide the LOCK / AL / TIME / CAL CAL set switch to position. The Year / Month Date digits will being to ash.
* Press button to set the correct month. HOUR / MONTH
* Press MIN / DATE button to set the correct date.
* Press button to set the correct year.12/24 / YEAR
* Slide the LOCK / AL / TIME / CAL LOCK set switch to after set your calender.
Using The Alarm
* Slide the set switch to position. The alarm indicator will light up.SNOOZE /AL ON / AL OFF AL ON
* Slide the set switch to the position to turn the alarm OFF.SNOOZE /AL ON / AL OFF AL OFF
The alarm indicator will disappear.
Using The Snooze
* Slide the set switch to position. The snooze indicator will light up.SNOOZE /AL ON / AL OFF SNOOZE SNOOZE
* Press the button when the alarm sounds will stop the alarm and the alarm will sound SNOOZE / LIGHT
again in 5 minutes.
* Slide the set switch to the position to turn the alarm OFF.SNOOZE /AL ON / AL OFF AL OFF
The snooze indicator will disappear.SNOOZE
12/24 Hour Formats
* Slide t the LOCK / TIME / AL LOCKset switch to position when changing the format of clock.
* Pressing the button to change your desired hour display format, a or indicator will appear 12/24 AM PM
on display in 12 hour mode.
www.equitybylacrosse.com/support
www.equitybylacrosse.com/support
PM
Indicator
ALARM
Indicator
TIME Display
SNOOZE / LIGHT Button
HOUR / MONTH Button
MIN / DATE Button
ALARM Time Display
NAP TIMER Button
12 / 24 / YEAR Button
MONTH / DATE Display
LOCK / AL / TIME/CAL Set Switch
Using The NAP TIMER
* Press the button to set the nap timer from 15 minutes to 4 hour by 15 minutes increment.NAP TIMER The
nap indicator will light up to conrm nap timer is activated after 3 seconds.
* During nap timer operation, press or button to stop the nap timer. The nap indicator .NAP TIMER SNOOZE / LIGHT
will disappear.
* To activate nap timer again, press button and will start from last setting.NAP TIMER
Using The Backlight
* Press the button to activate the display backlight . The backlight will stay on for 5 secondsSNOOZE LIGHT /
each time it is pressed.
Battery Warning
Clean the battery contacts and also those of the device prior to battery installation. Follow the polarity
(+) and (-) when inserting battery.
TI M EAL CAL
HOUR
MIN
MONTH
DATE
LOCK AL OFF
AL ON
SNOOZE
SNOOZE / LIGHT
MONTH
SN OOZE
DATE ALAR MPM
PM
12 / 24
YEAR
SNOOZE Indicator
Specyfikacje produktu
| Marka: | La Crosse Technology |
| Kategoria: | Radiobudzik |
| Model: | 31300 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z La Crosse Technology 31300, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Radiobudzik La Crosse Technology
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
7 Października 2024
Instrukcje Radiobudzik
- MT Logic
- Amplicomms
- REVO
- NGS
- Ditalio
- Vitek
- Tangent
- Muse
- AKAI
- Vivanco
- Livoo
- Brandt
- Trust
- Smartwares
- Mebus
Najnowsze instrukcje dla Radiobudzik
15 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024
8 Października 2024