Instrukcja obsługi Miele WDB030 Eco
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Miele WDB030 Eco (4 stron) w kategorii pralka. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 7.5 użytkowników na średnio 5.0 gwiazdek
Strona 1/4
WDB 030 en - AU, NZ M.-Nr. 10 832 550/00
Before the first use Operating the washing machine
OPERATING THE WASHING MACHINE
Washing
WASHING
Changing the programme sequence
CHANGING THE PROGRAMME SEQUENCE
Programme chart
3
1 2
4
ɉBefore using the machine for the first
time, ensure that it is correctly installed
and connected. Please read the separate
operating instructions supplied with the
appliance.
For safety reasons, spinning is not possible
until the machine has been prepared for use
for the first time. To activate the spinning
function, you must run a wash programme
without laundry and without detergent.
Using detergent could result in an exces-
sive build-up of foam.
This also activates the ball valve. The ball
valve prevents detergent escaping from the
suds container into the sump during a wash
programme, thus making maximum use of
the detergent.
Running the first programme
ĺTurn on the tap.
ĺTurn the programme selector to .Cottons
The washing machine is now switched on
and in the control panel, the temperature
60°C lights up.
ĺTouch the sensor.Start/Stop
The programme will start and the symbol
lights up in the control panel.
After the end of the programme
The symbol lights up in the control panel;
: appears in the time display and the
drum occasionally rotates.
ĺTouch the sensor.Start/Stop
The door will be unlocked.
ĺReach under the door grip and pull the
door open.
ĺWhen the programme has ended, turn
the programme selector to .
Note: For safety reasons close the door.
Washing environmentally and economically
–To make the most out of your machine,
load the maximum dry load for the pro-
gramme you are using.
–When smaller amounts of laundry are
washed, the automatic load recognition
system will reduce the amount of water
and energy used.
–Use the programme for Express 20
small, lightly soiled loads.
–Modern detergents enable washing at
reduced temperatures (e.g. 20°C). Use
appropriate temperature settings for
saving energy.
–Reduce the amount of detergent with
smaller loads (approx. ⅓ less than the
amount recommended can be used
when washing a half load).
–Selecting the highest possible spin
speed for the wash programme will
save energy when drying in a tumble
dryer afterwards.
1. Preparing the laundry
ĺEmpty all pockets.
ɉForeign objects (e.g. nails,
coins, paper clips, etc.) can
cause damage to garments and
components in the machine.
ĺSort the laundry by colour and by care label. Most gar-
ments have a textile care label in the collar or side seam.
ĺPre-treat stains and badly soiled areas (see the booklet
"Miele's guide to laundry care").
2. Loading the washing machine
Opening the door
ĺReach under the door grip and
pull the door open.
ĺUnfold the laundry and load
loosely in the drum.
Closing the door
ĺMake sure that no items are
caught between the door and
the seal.
ĺShut the door with a gentle
swing.
1 Detergent dispenser drawer
2 Control panel
3 Access to drain filter, drain pump
and emergency release
4 Door
3. Selecting a programme
The washing machine is switched on by turning the pro-
gramme selector to a wash programme.
Programme selection
ĺTurn the programme selector
to the required programme.
The likely wash time is shown in the time display and the
pre-set temperature and spin speed light up in the con-
trol panel.
Selecting a temperature/spin speed
The wash programme's pre-set temperature and spin
speed light up brightly. The choice of temperatures and
spin speeds selectable for the wash programme light up
dimly.
ĺTouch the sensor for the tem-
perature you want. It then
lights up brightly.
ĺTouch the sensor for the spin
speed you want. It then lights
up brightly.
Selecting Extra options
The selection of Extras available for the wash programme
lights up dimly.
ĺTouch the sensor for the Extra
you want. It then lights up
brightly.
Useful tip: You can select multiple Extras for a wash
programme.
4. Adding detergent
There are several options for adding deter-
gent.
Detergent dispenser drawer
ĺPull out the
detergent drawer
and add
detergent to the
compartments.
Detergent for the pre-wash
Detergent for the main wash,
including Soak if selected
/ Fabric softener, liquid starch or
capsules
CapDosing
Three different types of capsules are avail-
able:
Fabric care (e.g. fabric conditioner)
Additives (e.g. detergent enhancers)
Detergent
See "Detergent" in the operating instruc-
tions for more information.
5. Starting the programme
ĺTouch the flashing sensor.Start/Stop
The door will lock (the symbol will appear
in the control panel) and the programme will
start.
6. At the end of the programme
The time display shows : . The sym-
bol will remain lit up in the control panel.
The door is locked in the anti-crease phase.
ĺTouch the sensor.Start/Stop
ĺThe door unlocks and the symbol in
the control panel goes out.
ĺPull open the door.
ĺRemove the laundry.
ɉCheck that all items have been
removed from the drum.
ĺCheck the folds
in the door seal
for any small
articles, e.g.
buttons, which
might be lodged
there.
ĺTurn the programme selector to the
position. This switches the washing
machine off.
ĺIf applicable, remove the used capsule
from the detergent dispenser drawer.
ĺClose the door. Otherwise there is a dan-
ger of objects being placed inadvertently
in the drum. If these remain unnoticed
and were washed in the next load, they
could damage the laundry. An open door
is also a danger to pets and children.
Programme
Load
(inkg) Temperature Items Extras
Cottons 7.0 60°C⁄40°C Normally soiled cotton garments , , ,
Cottons 7.0 Cold to 90°C Cottons, linens or cotton mix fabrics, e.g. table linen, towelling,
underwear, T-shirts etc.
, , ,
Minimum iron 3.5 Cold to 60°C Synthetic, mixed fibre and easy care cotton , , ,
Delicates 2.0 Cold to 40°C Delicate garments made from synthetic fibre, mixed fibre, rayon
and viscose
, , ,
Woollens 2.0 Cold to 40°C Machine-washable or hand-washable wool or wool blend fabric
Shirts Cold to 60°C Shirts and blouses made of cotton and mixed fibre , , ,
Express 20 3.5 Cold to 40°C Cotton garments that have hardly been worn or are only very
lightly soiled.
Dark garments/
Denim
3.0 Cold to 60°C Black and dark garments made from cotton, mixed fibres and
denim
, , ,
Outerwear 2.5 Cold to 40°C Performance outerwear (e.g. jackets and trousers) made from
membrane fabric such as Gore-Tex®, SYMPATEX®, WIND-
STOPPER® etc.
, , ,
Proofing 2.5 40°C Treating microfibre fabric, skiwear and table linen made from
mainly synthetic fibres.
Drain/Spin 7.0 Drain only: Select for the spin speed.
Separate rinse/
Starch
7.0 For rinsing hand-washed items
Starching table cloths, serviettes and workwear
= Short; = Water plus; = Pre-wash; = Soak
1 Control panel
2 Sensor controls - temperature
for selecting the temperature
3 Sensor controls - spin speed
for selecting the spin speed
4 Sensor controls - Extras
various options can be added to the
wash programmes
5 Indicator lights
= Fault with the water inlet or
drainage
= Excess detergent was used
= Hygiene information
= Flashing: Laundry can be added
Lit up constantly: Door of the
washing machine is locked
6 CapDosing sensors
= Fabric care (e.g. fabric conditioner)
= Additives (e.g. detergent
enhancers)
= Detergent (for the main wash only)
7 Time display
After the programme has started, the
programme duration will appear in the
display in hours and minutes.
8 Sensor controls
for the Delay start function
9 Start/Stop sensor
Touching the Start/Stop sensor starts the
selected programme or cancels a pro-
gramme that has already been started.
The sensor flashes slowly as soon as it is
possible for a programme to be started
and then lights up constantly after the
programme has started.
10 Optical interface
for service technicians
11 Programme selector
for selecting programmes and for switch-
ing off. The washing machine is switched
on by selecting a programme, and
switched off by turning the programme
selector to the position.
Changing a programme
After the successful start of a programme
it is no longer possible to select a different
programme.
If you would like to change the programme
or add/remove laundry, you have to cancel
the programme.
Cancelling a programme
You can cancel a programme at any time
after it has started.
ĺTouch the sensor.Start/Stop
The water is pumped away and the time
display changes to : . As soon as the
symbol in the control panel goes out, the
programme has been cancelled and the
door can be opened.
Selecting a different programme after
cancelling the programme
ĺOpen the door.
ĺClose the door.
ĺCheck that there is still detergent in the
dispenser drawer. Add more detergent if
necessary.
ĺTurn the programme selector to the pro-
gramme you want and start it by touching
the sensor.Start/Stop
Removing laundry after cancelling the
programme
If you want to remove the laundry when it is
dripping wet:
ĺOpen the door.
ĺRemove the laundry.
If you want to remove the laundry
after it has been spun (damp):
ĺOpen the door.
ĺClose the door.
ĺTurn the programme selector to Drain/
Spin.
Useful tip: Select an appropriate spin
speed.
ĺTouch the sensor.Start/Stop
The laundry is spun and can be removed
damp after spinning.
Interrupting a programme
ĺTurn the programme selector to the
position.
The washing machine switches off.
ĺTo continue: Turn the programme selector
to the position of the wash programme
that was started.
Useful tip: If appears in the time dis-
play, the programme selector is in the incor-
rect position.
Adding or removing laundry
You can add or remove laundry at the start
of a wash programme as long as the
symbol is flashing in the control panel.
ĺBriefly touch the Start/Stop sensor.
The programme will stop and the door will
unlock.
ĺPull open the door.
ĺAdd or remove items.
ĺClose the door.
ĺTouch the Start/Stop sensor.
The wash programme will continue.
Specyfikacje produktu
| Marka: | Miele |
| Kategoria: | pralka |
| Model: | WDB030 Eco |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Miele WDB030 Eco, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje pralka Miele
9 Kwietnia 2025
3 Kwietnia 2025
2 Lutego 2025
19 Stycznia 2025
18 Stycznia 2025
18 Stycznia 2025
18 Stycznia 2025
18 Stycznia 2025
17 Stycznia 2025
17 Stycznia 2025
Instrukcje pralka
- Sunny
- Helkama
- Haden
- Zenith
- Friac
- Orion
- Everglades
- Panasonic
- Philco
- Technika
- Omega
- MPM
- Fisher Paykel
- Thor
- Benavent
Najnowsze instrukcje dla pralka
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
8 Kwietnia 2025