Instrukcja obsługi NEC MultiSync V801-DRD

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla NEC MultiSync V801-DRD (72 stron) w kategorii monitor. Ta instrukcja była pomocna dla 16 osób i została oceniona przez 7 użytkowników na średnio 4.3 gwiazdek

(1/72)

EXTERNAL CONTROL NEC LCD Monitor

Rev.3.8

INDEX

I. Application

................................................................................3

II. Preparation

...............................................................................4

2. Cs onnectorand wiring

....................................................................4

2.1 RS-232C Remote control

...............................................................4

2.2 LAN control

...........................................................................4

III. Communication specification

...............................................................5

3. Communication Parameter

................................................................5

3.1 RS-232C Remote control

...............................................................5

3.2 LAN control

...........................................................................5

3.3 Communication timing

.................................................................5

4. Communication Format

...................................................................6

4.1 Header block format xed(fi length)

......................................................7

4.2 Message block format

.................................................................9

4.3 Check code

..........................................................................11

4.4 Delimiter

............................................................................12

5. Message type

...........................................................................13

5.1 Get current Parameter from a monitor.

.................................................13

5.2 "Get parameter" reply

.................................................................14

5.3 Set parameter

........................................................................15

5.4 "Set parameter" reply

.................................................................16

5.5 Commands

...........................................................................17

5.5.1

Save Current Settings

. ............................................................17

5.5.2 Get Timing Repoand Timing rrt eply.

................................................18

5.5.3 NULL Message

....................................................................19

IV. Control Commands

.......................................................................20

6. Typical procedure example

...............................................................20

6.1. How to change the “Backlight se”tting.

................................................20

6.2. How to read the measurement value of the built-in temperature sensors.

..................23

6.3. Operation Code (OP code) Table

.......................................................26

7. Power l prcontroocedure

.................................................................36

7.1 Power status read

....................................................................36

7.2 Power control

........................................................................38

8. Asset Data read and write

................................................................40

8.1 Asset Data Read Request and reply

....................................................40

8.2 Asset Data write

.....................................................................42

Specyfikacje produktu