Instrukcja obsługi Sharp XR-50S

Sharp Projektor XR-50S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sharp XR-50S (79 stron) w kategorii Projektor. Ta instrukcja była pomocna dla 13 osób i została oceniona przez 7 użytkowników na średnio 4.1 gwiazdek

Pobierz PDF

Strona 1/79

Introduction Easy Start Setup Connections Basic

Operation

Useful

Features Appendix

OPERATION MANUAL

MUTIMEDIA PROJECTOR

MODEL

XR-55X

XR-50S

IMPORTANT

• For your assistance in reporting the loss

or theft of your Projector, please record

the Model and Serial Number located on

the bottom of the projector and retain this

information.

• Before recycling the packag ing, please

ensure that you have checked the con-

tents of the carton thoroughly against the

list of “Supplied accessories” on page .11

Model No.:

Serial No.:

iii

SPECIAL NOTE FOR USERS IN THE U.K.

The mains lead of this product is ﬁ tted with a non-rewireable (moulded) plug incorporating

a 10A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse

marked or and of the same rating as above, which is also indicated on the pin face

of the plug, must be used.

Always reﬁ t the fuse cover after replacing the fuse. Never use the plug without the fuse

cover ﬁ tted.

In the unlikely event of the socket outlet in your home not being compatible with the plug

supplied, cut off the mains plug and ﬁ t an appropriate type.

DANGER:

The fuse from the cut-off plug should be removed and the cut-off plug destroyed immedi-

ately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket

outlet, as a serious electric shock may occur.

To ﬁ t an appropriate plug to the mains lead, follow the instructions below:

WARNING:

THIS APPARATUS MUST BE EARTHED.

IMPORTANT:

The wires in this mains lead are coloured in accordance with the following code:

Green-and-yellow : Earth

Blue : Neutral

Brown : Live

As the colours of the wires in the mains lead of this apparatus may not correspond with

the coloured markings identifying the terminals in your plug proceed as follows:

• The wire which is coloured green-and-yellow must be connected to the terminal in the

plug which is marked by the letter E or by the safety earth symbol or coloured green

or green-and-yellow.

• The wire which is coloured blue must be connected to the terminal which is marked

with the letter N or coloured black.

• The wire which is coloured brown must be connected to the terminal which is marked

with the letter L or coloured red.

IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.

Authorized representative responsible for the European Union Community Market

SHARP ELECTRONICS (Europe) GmbH

Sonninstraße 3, D-20097 Hamburg

E.U. ONLY

Specyfikacje produktu

Marka:	Sharp
Kategoria:	Projektor
Model:	XR-50S
Waga produktu:	2800 g
Poziom hałasu:	35 dB
Moc wyjściowa (RMS):	7 W
Wyjścia słuchawkowe:	1
Zakres temperatur (eksploatacja):	5 - 35 °C
Współczynnik kontrastu (typowy):	2000:1
Wejscie Audio (L,P):	1
Liczba portów USB 2.0:	1
Pobór mocy:	265 W
Port RS-232:	1
Wymiary produktu (SxGxW):	300 x 236 x 79 mm
Liczba portów VGA (D-Sub):	1
Ilość wbudowanych glosników:	1
Zasięg skanowania w poziomie:	15 - 110 kHz
Zasięg skanowania (długość):	45 - 85 Hz
Ostrość:	Ręczny
Interfejs SCSI:	RS-232
Jasność projektora:	2700 ANSI lumenów
Technologia projekcji:	DLP
Naturalna rozdzielczość projektora:	SVGA (800x600)
Rodzaj źródła światła:	Lampa
Moc lampy:	210 W
Żywotność źródła światła:	4000 h
Wejście S-Video:	1