Instrukcja obsługi Smeg CR324PNF

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Smeg CR324PNF (23 stron) w kategorii lodówka. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 6 użytkowników na średnio 4.8 gwiazdek

DESCRIPTION OF PRODUCT

FINDKNSGRIPENLFGBD

GB

On / Off

Press to activate/deactivate the appliance.

Note: This operation does not disconnect the

appliance from the power supply.

Fan (where provided)

The fan is factory set to ACTIVE.

The fan can be deactivated by pressing the

button on the base (as shown in the figure). If

the room temperature exceeds 27°C or if

water droplets form on the glass shelves, the

fan must be on in order to guarantee the

correct preservation of food. Deactivation of the fan enables energy

consumption to be optimised.

Fast Cool Function

Press the "Temperature" button for 3 seconds to cool the

refrigerator compartment quickly, or 6 hours before placing large

quantities of fresh food in the freezer compartment. When the

function is active, the yellow light is on and the three green lights

are off. This function is automatically deactivated after 30 hours, or

manually by pressing the button again for 3 seconds. When the

function is not active, the yellow light is off and the indication of the

set temperature is shown by the green lights.

Note: Do not place fresh food to be frozen in direct contact with

already frozen food.

5019 608 01100

Printed in Italy 11/11

Refrigerator compartment temperature

The three green lights indicate the set refrigerator compartment

temperature.

A different temperature can be set using the "Temperature "

button.

The following adjustments are possible:

LED's onSet temperature

High (least cold)

Medium-high

Intermediate

Medium-low

Low (coldest)

Refrigerator Compartment

A. Fan and antibacterial and antiodour filter (depending

on the model)

B. Lamp or LED light (depending on the model)

C. Shelves

D. LED lights (depending on the model)

E. Crisper drawer cover

F. Crisper(s)

G. Rating plate (located at side of crisper)

H. Control panel

N. Dairy compartment

O. Door trays

P. Bottle holder (if provided)

Q. Bottle bin

Least cold zone

Intermediate zone

Coldest zone

Fruit and vegetable zone

Freezer Compartment

I. Top drawer (freezing area)

L. Middle and bottom drawers (storage area for frozen

and deep frozen food)

M. Ice cube tray (if provided)

Note: All shelves, door trays and racks are removable.

The ideal temperatures for preserving foods are already

factory-set.

Carefully read the user handbook provided before

using the appliance.

The characteristics, technical data and images may

vary according to the model.

What to do if...Possible causes:Cures:

The control panel is switched off, the appliance does not work.

The appliance could be in off mode.

There may be an appliance power supply problem.

Activate the appliance with the On/Off button

Make sure:

- there is not a power outage

- the plug is properly inserted in the power socket and the mains double-pole switch (if present) is in the correct position

(i.e. allows the appliance to be powered)

- the household electrical system protection devices are efficient

- the power cable is not broken.

The inside light does not work.The light may need replacing.

Models with lamp: disconnect the appliance from the power supply, check the lamp and, if necessary, replace it with a

new one (see the section "Lamp or LED replacement").

Models with LED lights: contact the authorised Service Centre.

The temperature inside the compartments is not low enough.There could be various causes (see "Cures")

Make sure:

- the doors close properly

- the appliance is not installed near a heat source

- the set temperature is adequate

- the circulation of air through the vents at the bottom of the appliance is not obstructed

There is water on the bottom of the refrigerator compartment.

The defrost water drain is blocked.Clean the defrost water drain hole (see the section "Appliance Maintenance and Cleaning")

The front edge of the appliance, at the door striker seal, is hot.This is not a defect It prevents condensation from forming.No remedy is necessary.

One or more indicator lights flash.Malfunction alarm

The alarm indicates a fault in a technical component.

Call the authorised Service Centre.

The appliance continues to maintain minimum preservation conditions.

Specyfikacje produktu