Instrukcja obsługi AmpliVox Chancellor SW470

AmpliVox Niesklasyfikowane Chancellor SW470

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AmpliVox Chancellor SW470 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 37 osób i została oceniona przez 19 użytkowników na średnio 4.3 gwiazdek

Strona 1/4
CONTROL PANEL
Electronic Instructions
Lectern
Your lectern may not contain all of the electronic modules as shown and explained here. Speakers and lectern
microphone are pre-wired. To install gooseneck microphone, pull out connector from microphone holder and
snap microphone into connector. Install back into microphone holder.
NEED HELP? Call 800-267-5486
16 CHANNEL WIRELESS RECEIVER
1. MIC 1: Adjusts volume level of gooseneck microphone
on reading table.
2. MIC 2: Adjusts volume level of microphone plugged
into the MIC 2 input jack on amplier.
3. AUX: Controls output level of device that is plugged
into the L/R RCA jacks.
4. This control cuts or boosts the bass level. BASS:
5. This control cuts or boosts the treble level. TREBLE:
RECEIVER / TRANSMITTER SETUP:
· The receiver has its own POWER / VOLUME Control (G).
Turn Power On. A Frequency Channel will appear in the Chan-
nel Display (A). Press Select Buttons ( ) to select a channel. E
Channel number must match channel number on wireless
transmitter.
· The transmitter bodypack is operated by 1 - "AA" 1.5 Volt alka-
line battery. Slide o battery cover and install battery as (H)
shown. Make certain the battery is fully seated in its compart-
ment so the cover slides in place easily. Battery life with alka-
line batteries is approximately 8 hours of operating time.
· Select a channel (1-16) on side panel using the supplied (I)
screw driver to select channel number. Channel selected
should match channel on receiver. When transmitter and
receiver are set to correct channel the RF indicator (B) will
glow red when transmitter is turned on.
· Plug the Lapel microphone into the Mic Input Jack (K). The
microphone can be clipped to a necktie or other clothing,
using the supplied clip. The lapel mic should be placed under
the chin, as close to the center of the body as possible.
· Slide the power switch to the position (the ON/OFF (J) ON
LED indicator light will illuminate green). Replace batteries
when this LED turns red.
MUTE LEVEL (F) is set at half way mark when it leaves the
factory. If speaker sound is breaking up, turn level clockwise
with small screwdriver until condition improves.
· Channel Display (A)
· RF - Radio Frequency Indicator (B)
· AF - Audio Frequency Indicator (C)
· ASC / IR Auto Channel Select (Handheld Only) (D)
· Select Buttons - Manual Channel Selection (E)
· Mute Level Adjustment (F)
· Volume Control (G)
A B C D
E F G
1 2 3 4 5
Wireless Transmitter - Bodypack
Battery Cover
H
Channel Selector
I
Top Panel
J K


Specyfikacje produktu

Marka: AmpliVox
Kategoria: Niesklasyfikowane
Model: Chancellor SW470

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z AmpliVox Chancellor SW470, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane AmpliVox

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

SmallRig

SmallRig VB99 SE Instrukcja

29 Stycznia 2025
QSC

QSC TSC-8 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5130 Instrukcja

29 Stycznia 2025
Sunding

Sunding SD-581G Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS5070 Instrukcja

29 Stycznia 2025
XTRARM

XTRARM XTR-FS2010 Instrukcja

29 Stycznia 2025
OSEE

OSEE TX402 Instrukcja

29 Stycznia 2025