Instrukcja obsługi AXESS AXSWC-WR

AXESS Niesklasyfikowane AXSWC-WR

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AXESS AXSWC-WR (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 17 osób i została oceniona przez 9 użytkowników na średnio 4.7 gwiazdek

Pobierz PDF

Strona 1/1

ASWC-1

INSTALLATION INSTRUCTIONS

Integrate • AxxessInterfaces.com

Manual Programming

If the auto programming sequence fails even after following the troubleshooting steps, the ASWC-1 may be able to be manually programmed to the vehicle. This document only applies to resistive

based steering wheel control vehicles (non-data communication vehicles that

do not

use the wire for steering wheel control). Please read these steps beforehand to have a clear understanding of Pink

what is to be expected. This is a timed process. The procedure is broken up into 2 steps for reference, but the entire process must be completed.

Attention! If more than 20 seconds elapses between steps, the procedure will abort.

Vehicle programming section:

Turn the key to ignition.1.

2. Press and hold the Reset button in the ASWC-1 for approximately 15 seconds, or until the ASWC-1’s light ﬂashes slowly . Release the button at this point.Red/Green Reset

Press and hold the 3. Volume Up button on the steering wheel until the ASWC-1’s light goes solid , then release. The light will then go out indicating Green

Volume Up

has now been programmed.

If the ASWC-1’s light doesn’t go solid after 7 seconds, there may be a problem with the vehicles button.Note: Green Volume Up

Press and hold the Volume Down button on the steering wheel until the ASWC-1’s light goes solid , then release. The light will then go out indicating Green Volume Down has now been programmed

Continue from in the 5. Seek Up / Next Manual Programming Legend to reference the order in which the steering wheel control buttons must be programmed.

If a function in the legend is not present on the steering wheel, press the button on the steering wheel until the ASWC-1’s light turns on solid , then release. Note: Volume Up Green

This will tell the ASWC-1 to skip that function.

6. After the last steering wheel control button has been programmed, press and hold the button on the steering wheel until the ASWC-1’s light ﬂashes slowly Volume Up Red/Green, then release.

Radio programming section:

7. Press and hold the Volume Down button on the steering wheel until the ASWC-1’s light ﬂashes rapidly Red/Green, then release.

8. After approximately 4 seconds, the ASWC-1’s light will go out for a couple seconds. The light will then ﬂash up to 18 times depending on which radio is installed.Red

9. If the Red ﬂashes

match the radio installed, continue on to step 10. If the ﬂashes Red

do not

match the radio installed, press and hold the Volume Up button on the steering wheel until the

ASWC-1’s light turns on solid , then release. Repeat this step for the desired radio number selected. Reference the Red Radio Legend. Continue on to step 10 from this point.

10. Volume DownPress and hold the button on the steering wheel until the ASWC-1’s light goes solid .Red

11. This is the end of the manual programming sequence. Test the steering wheel controls for functionality.

Manual Programming Legend Radio Legend

Function # Function

1 Volume Up

2 Volume Down

3 Seek Up / Next

4 Seek Down / Previous

5 Source / Mode

6 Mute

7 Preset Up

8 Preset Down