Instrukcja obsługi Blaze B500
Blaze
Podgrzewacz
B500
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Blaze B500 (10 stron) w kategorii Podgrzewacz. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 8 użytkowników na średnio 4.7 gwiazdek
Strona 1/10
Revision B
Operang Instrucons
Contemporary and Stylish
Keep instrucons for future reference
Glen Dimplex Australia proudly supports the acvies of Landcare Australia through its membership of the AHHA
B500
B800
1
CONTENTS
1. OPERATING ....................................................................... 1
1.1. INTRODUCTION ....................................................... 1
1.2. GENERAL OPERATION ............................................. 2
1.2.1. AIR CONTROL 2 ......................................................
1.2.2. DOOR HANDLE .................................................... 2
1.2.3. FAN...................................................................... 2
1.3. USING THE APPLIANCE FOR THE FIRST TIME ........... 2
1.4. RECOMMENDED FUELS ........................................... 2
1.5. LIGHTING THE FIRE .................................................. 2
1.6. RUNNING THE APPLIANCE ....................................... 2
1.7. BURNING TIPS .......................................................... 3
1.8. ASH REMOVAL ......................................................... 3
1.9. FLUE/CHIMNEY FIRE ................................................ 4
1.10. CLEANING PAINT WORK AND GLASS ....................... 4
1.11. CLEANING THE FLUE ................................................ 4
1.12. TROUBLESHOOTING TIPS 4 ........................................
2. MAINTENANCE AND SERVICING ....................................... 5
2.1. REPLACING THE FIRE BRICKS ................................... 5
2.2. REPLACING THE BRICK RETAINER ............................ 5
2.3. REPLACING THE BAFFLE PLATE ................................ 6
2.4. REPLACING THE ASH PLATE ..................................... 7
2.5. REMOVING THE DOOR 7 ............................................
2.6. ADJUSTING THE DOOR 7 ............................................
2.7. REPLACING DOOR GLASS ......................................... 7
2.8. REPLACING THE DOOR SEAL .................................... 8
2.9. DOOR HANDLE ADJUSTMENT .................................. 8
2.10. REPLACEMENT SPARE PARTS LIST ........................... 9
1. OPERATING
1.1. INTRODUCTION
Before use of this appliance please read these instrucons
fully.
WARNING: ANY MODIFICATION OF THE APPLIANCE THAT
HAS NOT BEEN APPROVED IN WRITING BY THE TESTING
AUTHORITY IS CONSIDERED AS BREACHING AS/NZS 4013.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AEROSOLS
TO START OR REKINDLE THE FIRE.
WARNING: DO NOT USE FLAMMABLE LIQUIDS OR AEROSOLS
IN THE VICINITY OF THIS APPLIANCE WHEN IT IS OPERATING.
WARNING: DO NOT STORE FUEL WITHIN HEATER
INSTALLATION CLEARANCES.
WARNING: WHEN OPERATING THIS APPLIANCE AS AN OPEN
FIRE USE A FIRE SCREEN.
WARNING: OPEN AIR CONTROL (AND DAMPER WHEN
FITTED) BEFORE OPENING FIRING DOOR.
WARNING: DO NOT BURN WOOD THAT IS PAINTED; OR IS
COATED WITH PLASTIC; OR HAS BEEN TREATED WITH ANY
CHEMICAL.
CAUTION: THIS APPLIANCE SHOULD NOT BE OPERATED WITH
A CRACKED GLASS.
CAUTION: THIS APPLIANCE SHOULD BE MAINTAINED AND
OPERATED AT ALL TIMES IN ACCORDANCE WITH THESE
INSTRUCTIONS.
The appliance or ue system should not be modied in any
way without the wrien approval of the manufacturer.
Extractor fans or cooker hoods must not be placed in the
same room or space as this can cause appliance to emit smoke
into the room.
Our Cleanburn technology promotes greater eciency
THE OPERATING INSTRUCTIONS IN THIS MANUAL APPLY
TO THE BLAZE B50 AND B80 FREE STANDING WOOD 0 0
HEATER MODELS.
THEY HAVE BEEN TESTED FOR EMISSIONS AND
EFFICIENCY AND COMPLY ACCORDING TO AS/NZS 4012 &
AS/NZS 4013.
2
1.2. GENERAL OPERATION
1.2.1. AIR CONTROL
The B50 and B800 models feature a single air control system 0
designed to introduce oxygen the base of the re. The air to
control is operated by sliding the handle located to the le
above the door. Slide le to open air control for high burn
rate and right to close for low burn rate.
Secondary air holes in the rear of the rebox provide
addional oxygen for more complete combuson of the gases
released from the burning wood.
1.2.2. DOOR HANDLE
Warning: The door handle may get hot if the appliance has
been le in the high burn seng for an extended period. Use
the supplied door handle extension (see image below) or a
protecve glove to open.
Open the air slide before opening the door to eliminate the
chance of backdra and smoke entering the room.
1.2.3. FAN
The fan can be used help spread the heat around the room to
and other rooms faster The fan does not have to be on when .
the heater is in use, and may be switched on or o at any
me.
1.3. USING THE APPLIANCE THE FIRST TIME FOR
For the rst few mes the appliance is lit, odorous fumes
will be given o as the paint cures.
Do not touch the paint work while it is curing otherwise it
can leave a permanent mark on the appliance.
Keep the room well venlated unl these fumes have
cleared.
Once the paint has cured, this will not re-occur.
1.4. RECOMMENDED FUELS
Burn only seasoned hardwood mber with a moisture
content of less than 20%.
Newly cut wood should be allowed to dry/season for 12
to 18 months before use.
Wood should be stored in an environment protected
from the weather to minimise any potenal moisture
content.
For best results, wood should not exceed ¾ of the rebox
front to back dimension in length and 150mm in
diameter. Any larger and appliance will not operate at its
opmum. It is beer to burn several smaller pieces of
wood than one large piece at a me.
Poor quality timber:
o Causes low combuson eciency.
o Produces poor emissions (smoky).
o Results in addional build- of creosote (soot) up
in the ue which will then require regular
cleaning and may result in a ue re.
Do not burn painted, impregnated/treated wood,
manufactured board products or pallet wood.
1.5. LIGHTING THE FIRE
1) Place relighters or paper and dry kindling wood in the
base of the rebox.
2) Open air control.
3) Light the paper or relighters.
4) If necessary, leave the door slightly open as the re
establishes and the glass warms to avoid build-up of a
condensaon.
5) Once the re has taken hold add larger pieces of wood.
For opmal burn condions, place the logs in a front to
back orientaon (right angles to the door opening). Too
many logs may smother the re.
6) Once the re is established, close the door.
Do not leave unattended while the door is the appliance
open.
1.6. RUNNING THE APPLIANCE
Maximum Heat Output
This seng is not the most energy ecient as some heat is
lost up the ue instead of being transferred into the room.
However, once re has established, parculate emissions will
be very low (clean burning).
Aer establishing the re and loading it with larger pieces
of wood, leave it running with the air slide fully open to
generate maximum heat output.
Specyfikacje produktu
| Marka: | Blaze |
| Kategoria: | Podgrzewacz |
| Model: | B500 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Blaze B500, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Podgrzewacz Blaze
22 Września 2024
20 Września 2024
16 Września 2024
14 Września 2024
13 Września 2024
11 Września 2024
8 Września 2024
6 Września 2024
6 Września 2024
6 Września 2024
Instrukcje Podgrzewacz
- Podgrzewacz AKO
- Podgrzewacz Igenix
- Podgrzewacz Kunft
- Podgrzewacz Grandhall
- Podgrzewacz Broan
- Podgrzewacz MPM
- Podgrzewacz Suntec
- Podgrzewacz HQ
- Podgrzewacz Defy
- Podgrzewacz Noveen
- Podgrzewacz SuperFish
- Podgrzewacz Arnold Rak
- Podgrzewacz Eta
- Podgrzewacz Orbegozo
- Podgrzewacz EvoHeat
Najnowsze instrukcje dla Podgrzewacz
4 Kwietnia 2025
4 Kwietnia 2025
3 Kwietnia 2025
2 Kwietnia 2025
30 Marca 2025
30 Marca 2025
29 Marca 2025
29 Marca 2025
27 Marca 2025
27 Marca 2025