Instrukcja obsługi Chamberlain 041A6241

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chamberlain 041A6241 (4 stron) w kategorii Maszyna do śrub. Ta instrukcja była pomocna dla 18 osób i została oceniona przez 8 użytkowników na średnio 4.5 gwiazdek

Universal Replacement Instructions

Screw Drive Motor

You will need a 1/4" magnetic nut driver, long-nosed pliers,

and a 5/16 long-shafted magnetic nut driver.

1. Disconnect power to the opener.

2. Remove the cover.

3. Remove endpanels.

4. Unplug the wire harness from the RPM sensor.(A)

5. Observe the 3 wires leading from the motor and note

their position for reassembly:

• Disconnect the single white wire from the terminal

block . (B)

• Disconnect the other two (red and blue) from the

capacitor .(C)

6. Remove the 4 screws fastening the motor bracket to (D)

the chassis, using a 5/16 long-shafted magnetic driver.

Hand-support motor before removing final screw.

7. Remove entire motor/bracket assembly and discard.

8. Replace with new motor.

9. Reverse steps 2-7 to reassemble.

10. Reconnect power.

NOTE: A test of the Safety Reverse System is necessary for safe

operation. Follow the instructions on side two or in your

owner’s manual.

To prevent possible SERIOUS INJURY or DEATH from

electrocution, disconnect power to opener BEFORE

proceeding.

The garage door MUST be in the fully closed position during

installation.

D

D

D

D

C

B

A

1

Specyfikacje produktu