Instrukcja obsługi Chief MCD6364
Chief
Wsparcie dla płaskich paneli
MCD6364
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief MCD6364 (8 stron) w kategorii Wsparcie dla płaskich paneli. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 5 użytkowników na średnio 5.0 gwiazdek
Strona 1/8
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Dual Ceiling Mount
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
MCD Series
MCD Series Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of all
components located between the supporting structure and the
mount does not exceed 250 lbs (113.4 kg) [125 lbs (56.7 kg)
each faceplate].
•The weight capacity of the mount may be LIMITED to
the lowest capacity of any other component located
between the mount and the supporting structure!
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
--SAVE THESE INSTRUCTIONS--
Installation Instructions MCD Series
3
DIMENSIONS
LEGEND
1.01
10.15
FACE TILTS
5
UP
20
DOWN
FACE TILTS
5
UP
20
DOWN
4.01
8.02
1-1/2" NPSM
APPROXIMATE CENTER
OF DISPLAY
TOP MOUNTING BUTTON ON
MSB-XXXX DRAWING GOES HERE
NOTE: CUSTOM INTERFACE BRACKET
NOT SHOWN. THE CUSTOM INTERFACE
BRACKET NEEDED FOR YOUR DISPLAY
WILL ADD BETWEEN 1/2" AND 2" IN
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
Specyfikacje produktu
| Marka: | Chief |
| Kategoria: | Wsparcie dla płaskich paneli |
| Model: | MCD6364 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Chief MCD6364, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Wsparcie dla płaskich paneli Chief
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
Instrukcje Wsparcie dla płaskich paneli
- Wsparcie dla płaskich paneli Luxor
- Wsparcie dla płaskich paneli Ematic
- Wsparcie dla płaskich paneli Anthro
- Wsparcie dla płaskich paneli Atlantic
- Wsparcie dla płaskich paneli Multibrackets
- Wsparcie dla płaskich paneli NeoMounts
- Wsparcie dla płaskich paneli SMS Smart Media Solutions
- Wsparcie dla płaskich paneli Kogan
- Wsparcie dla płaskich paneli Sanus
- Wsparcie dla płaskich paneli Kensington
- Wsparcie dla płaskich paneli BenQ
- Wsparcie dla płaskich paneli Wentronic
- Wsparcie dla płaskich paneli Mount-It!
- Wsparcie dla płaskich paneli Steren
- Wsparcie dla płaskich paneli One For All
Najnowsze instrukcje dla Wsparcie dla płaskich paneli
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
28 Stycznia 2025
28 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025