Instrukcja obsługi Chief SL236SP
Chief
Wsparcie dla płaskich paneli
SL236SP
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Chief SL236SP (16 stron) w kategorii Wsparcie dla płaskich paneli. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 6 użytkowników na średnio 4.6 gwiazdek
Strona 1/16
I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television
communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a circuit other than that to which the receiver is connected
Consult the dealer or and experienced radio/TV technician for help
SL236
SMART-LIFT™ Electric Ceiling Lift
SL236 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies, and its affiliated corporations and
subsidiaries (collectively, "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: FAILURE TO READ AND
FOLLOW THE FOLLOWING INSTRUCTIONS CAN RESULT
IN SERIOUS PERSONAL INJURY, DAMAGE TO EQUIPMENT
OR VOIDING OF FACTORY WARRANTY. It is the installer’s
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
IMPORTANT ! : Model SL236 is suitable for use in Other
Environmental Air Space in Accordance with Section 300.22(C)
of the National Electrical Code.
When using an electrical mounting system, basic precautions
should always be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS
PRODUCT!!!!
DANGER: TO REDUCE THE RISK OF
ELECTRIC SHOCK:
1. Always turn off power at source before cleaning.
WARNING: TO REDUCE THE RISK OF
BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS:
• Always turn off power at source before putting on or
taking off parts.
• Use this mounting system only for its intended use as
described in these instructions. Do NOT use
attachments not recommended by the manufacturer.
• Never operate this mounting system if it has a
damaged test cord or test plug. If it is not working
properly during testing, return the mounting system to
a service center for examination and repair.
• Keep the test power cord away from heated surfaces.
• Never operate the mounting system with the air
openings blocked. Keep the air openings free of lint,
hair, and the like.
• Never drop or insert any object into any opening.
• Do not use outdoors unless marked for outdoor use.
• Route cords and cables as shown in the installation
instructions.
• To disconnect, turn all controls to the off position, then
turn off power at source.
WARNING: RISK OF ELECTRIC SHOCK!
Connect this mounting system to a properly grounded outlet
only. See Grounding Instructions.
CAUTION: Changes or modifications to this
unit not expressly approved by the manufacturer can void the
units FCC compliance rating and make the unit illegal to
operate.
WARNING: Failure to provide adequate
structural strength for this component can result in serious
personal injury or damage to equipment! It is the installer’s
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component.
WARNING: Exceeding the weight capacity
can result in serious personal injury or damage to equipment! It
is the installer’s responsibility to make sure the weight of all
components attached to the SL236 does not exceed 35 lbs
(15.9 kg).
WARNING: RISK OF INJURY! Do not place
video equipment such as televisions or computer monitors on
the ceiling panel of the SL236. The total weight of any objects
on the ceiling panel must not exceed 5 lbs (2.3 kg).
NOTE: This system has no user serviceable parts.
--SAVE THESE INSTRUCTIONS--
Installation Instructions SL236
3
TOOLS REQUIRED FOR INSTALLATION
PARTS
x1
I/M
A (1)
B (1)
C (5)
D (1)
E (1)
F (5)
G (4)
6-32 x 3/16 H (2)
[Ceiling Lift]
[Push Button Assembly]
[Cable Tie]
[Cable Tie
Mount]
[External Terminal
Cover Plate]
[Rubber Grommet]
[Jumper Wire]
(SL236FD Shown)
Specyfikacje produktu
| Marka: | Chief |
| Kategoria: | Wsparcie dla płaskich paneli |
| Model: | SL236SP |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Chief SL236SP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Wsparcie dla płaskich paneli Chief
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
Instrukcje Wsparcie dla płaskich paneli
- Wsparcie dla płaskich paneli AMX
- Wsparcie dla płaskich paneli HQ
- Wsparcie dla płaskich paneli LTN Technologies
- Wsparcie dla płaskich paneli Konig
- Wsparcie dla płaskich paneli NeoMounts
- Wsparcie dla płaskich paneli Abus
- Wsparcie dla płaskich paneli Equip
- Wsparcie dla płaskich paneli SMS Smart Media Solutions
- Wsparcie dla płaskich paneli Proaim
- Wsparcie dla płaskich paneli Panduit
- Wsparcie dla płaskich paneli Peerless
- Wsparcie dla płaskich paneli Gabor
- Wsparcie dla płaskich paneli Crimson
- Wsparcie dla płaskich paneli Bretford
- Wsparcie dla płaskich paneli SunBriteTV
Najnowsze instrukcje dla Wsparcie dla płaskich paneli
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
29 Stycznia 2025
28 Stycznia 2025
28 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025
16 Stycznia 2025