Instrukcja obsługi Cobra SPX 6700

Cobra nawigator SPX 6700

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Cobra SPX 6700 (2 stron) w kategorii nawigator. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 4.5 użytkowników na średnio 4.9 gwiazdek

Pobierz PDF

Strona 1/2

Maximum Performance

Radar/Laser Detector

SPX 6700

Operating Instructions

NOTE: This device complies with part 15 of FCC rules: Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any interference received

including interference that may cause undesired operation.

CAUTION: Modiﬁcations or parts not approved by Cobra Electronics

Corporation may violate FCC Rules and void authority to operate this equipment.

Printed in the Philippines Part No. 480-888-P Version G

Thank you for purchasing Cobra’s maximum performance

radar/laser detector. Please read this manual to familiarize

yourself with the various features your detector offers.

Controls and Connections

Windshield Bracket

Mounting Slot

Power/Volume

Control

12V Power Jack

IntelliMute Button

• Press to turn

IntelliMute On/Off.

• Press & hold to set

IntelliMute.

• Also enters IntelliMute

setting mode (see

IntelliMute section).

Mute/Set Button

• Press once to manually

mute audio alerts.

• Press & hold to switch

between Voice or Tone

Alert*

City Button

• Press to select City

(filtering) Mode or

Highway Mode.

• Press & hold to turn

Low Car Voltage

Warning On/Off.

Dim Button

• Press to cycle through

different brightness

settings.

• Press & hold to turn

SmartPower On/Off.

Mounting

Your detector should be mounted on the windshield or dashboard of

your vehicle. Two mounting options are included:

Suction Cup Mount –

This is the best option for portability and mov-

ing the detector from car to car. Make sure to

thoroughly clean the suction cups and wind-

shield mounting area to insure a tight seal.

Hook and Loop Fastener–

Included for dashboard mounting.

Suction Cup Mount

Hook & Loop Fastener

Your detector should be mounted so that it is oriented

parallel to the road.

The suction cup mount comes standard bent at

a 45° angle. The metal is designed to bend

without breaking. Adjust the angle so when

mounted the detector is level with the road.

Avoid blocking the detector’s view by windshield wiper

blades or dark tinting at the top of the windshield.

Note: Do not attempt to bend the mount while the detector

is attached.

Windshield

Incorrect Positions

Correct Position

Powering

Plug in your detector using the included

cigarette lighter adapter.

Turn your detector on/off by pressing the

Power/Volume switch on the side of the

unit. The unit will light up.

12V Cigarette Lighter Adapter

12V Power Jack

Power/Volume Control

Types of Screens

1. Standby Screen

City/Highway Indicator: Shows current ﬁltering mode.

Vehicle Battery Voltage: Displays your car battery voltage and

automatically warns you if this drops below 11.9V.

Car Battery Low Voltage Warning

In addition to displaying system voltage, your detector can pro-

vide a warning that battery voltage is low so that timely steps

can be taken to correct the problem. The Car Battery Low alert

is triggered when the voltage drops below 11.9 volts. Following

the alert, the unit enters SmartPower mode to avoid further

draining your car battery.

IntelliMute Indicator: Indicates status of IntelliMute.

See IntelliMute section for details.

• Press to turn power

On and Off.

• Push forward

or pull back to

adjust volume.

2. Alert Screens

Radar bands consist of X-band, K-band, Ka-band, and Ku-band. With

radar signals, the signal strength meter shows the strength of the radar

gun as well as relative proximity to the source. With Ka-band, you will

also be notiﬁed of the actual Ka-band radar gun frequency being used.

With Laser signals, you will always receive full alert and pulse rate

(PPS) of the corresponding laser gun being used. Laser PPS currently in

use are: 100, 125, 130, 200, 238 and 340.

Ka Band Alert

Signal Strength

Frequency

Laser

Pulse

Rate

• Level 1=

Weakest Signal

• Level 5=

Strongest Signal

* See Buttons and

Controls chart for

additional information.

LaserEye

For 360° detection

of laser signals.

Buttons and Controls Quad-level IntelliSheild™ False Signal Rejection: Highway

Mode provides full immediate response to all signals detected.

Use this mode when you are driving on interstate highways.

Automatic door openers operate in X and K-band frequencies.

To minimize unwanted false alerts in an urban environment where

these sources exist, use one of the City Filtering Modes below:

• City X:

automatically mutes X-band audible alert

until signal strength reaches level 3 or above.

• combined with City X, City X+K:

automatically mutes K-band audible alert

until signal strength reaches level 2 or above.

• combined with City X+K, City Plus X+K+Ka:

adds ﬁltering to Ka-band.

• Maximum ﬁltering against urban City MAX:

false signal sources.

The modes can also be adjusted by pressing the button City City

for 2 seconds.

IntelliMute®: IntelliMute allows you to avoid audible alerts you

don’t need to hear because you are stopped or moving slowly. By

sensing the RPMs of your engine, IntelliMute knows when you

are at low speed and automatically mutes alerts. You can set

your preferred engine RPM activation point and/or turn on/off

IntelliMute by the IntelliMute button for more than 2 seconds.

You can change your detector’s user/alert settings by pressing one

or more of the Control buttons as shown below.

Function Press Button

Dim IMute Mute City

Single Button Press:

SmartPower On/Off >4 Seconds •

IMute On/Off/ Pro <2 Seconds •

IntelliMute-Set Activation RPM >2 Seconds •

Auto Mute On/Off <2 Seconds •

Voice/Tone >2 Seconds •

Double Button Press:

Low Car Voltage Warning On/Off >2 Seconds •

X Band On/Off >4 Seconds • •

Ku Band On/Off >4 Seconds • •

Safety Alert On/Off >4 Seconds • •

VG-2 and Spectre On/Off >4 Seconds • •

POP Alert On/Off >4 Seconds • •

Specyfikacje produktu

Marka:	Cobra
Kategoria:	nawigator
Model:	SPX 6700
Kolor produktu:	Czarny
Rodzaj żarówki:	LED
Materiał obudowy:	Glass,Stainless steel
Typ kontroli:	Dotyk
Wbudowany wyświetlacz:	Tak
Częstotliwość wejściowa AC:	50/60 Hz
Napięcie wejściowe AC:	220 - 240 V
Szerokość produktu:	900 mm
Głębokość produktu:	340 mm
Poziom hałasu:	64 dB
Klasa wydajności energetycznej:	B
Minutnik:	Tak
Model:	Naścienny
Roczne zużycie energii:	63 kWh
Prędkości:	4
Maksymalna moc ekstrakcji:	595 m³/h
Rodzaj ekstrakcji:	Kanałowy
Klasa wydajności przepływu dynamicznego:	B
Klasa wydajności świecenia:	A
Klasa skuteczności filtra przeciwtłuszczowego:	E
Poziom hałasu (niska prędkość):	46 dB
Rodzaj filtra tłuszczu:	Aluminium
Moc silnika:	- W
Wysokość bez komina:	405 mm
Wysokość (min):	1055 mm
Wysokość (max.):	1365 mm
Prędkość w trybie intensywnym:	Tak
Poziom hałasu (wysoka prędkość):	58 dB
Średnica przyłącza odprowadzającego dym:	150 mm
Liczba filtrów:	1 szt.
Lokalizacja wydechu:	Górne