Instrukcja obsługi Crestron ST-RMK

Crestron nieskategoryzowany ST-RMK

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Crestron ST-RMK (4 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 30 osób i została oceniona przez 15.5 użytkowników na średnio 4.7 gwiazdek

Pobierz PDF

Strona 1/4

Rack Mount Kit: ST-RMK

Physical Description

The ST-RMK is a rack mount kit that is capable of holding either one or two CEN Ethernet Modules,

SmarTouch STS Expansion Modules, ST-CP Control Processors, or any combination of units in a

single rack space. The front extrusion and bracket are provided to occupy the open bay of the ST-RMK

so that when only one module (or ST-CP) is installed, no gaps are visible in the rack. The front

extrusion and bracket may be installed in either the left or right bay of the ST-RMK. When the

ST-RMK accommodates two modules, the extrusion and bracket are not used.

Items 1 through 6 listed below are the supplied components of the ST-RMK. The tools required for

installation of the ST-RMK are a #1 Phillips 1/4-inch hex bit, a 1/4-inch hex socket, and an inch-pound

torque driver. Follow the installation procedures in the next section.

Supplied Components

ITEM DESCRIPTION PART NUMBER QUANTITY

1 Assembly, chassis & front extrusion AY17489-1 1

2 Assembly, front extrusion & label AY17490-1 1*

3 Bracket MTBK02315-1 1*

4 Screw, 4-40 x 1/4"L, steel, pan, phillips, black SR04-40-0R2500-8 8*

5 Nut, 4-40, hex, steel, zinc MTPL02390-1 4

6 Washer, lock, steel, internal, #4, zinc WA04L0-1 4

* Depending upon number of modules installed, not all items may be required.

Rack Mount Instructions

Front Extrusion and Bracket Installation

If two modules (or ST-CPs) are to be installed onto the ST-RMK, skip this procedure and proceed to

the next section. If only one module is to be installed, the front extrusion and bracket should be

installed into either the left or right bay of the chassis. To install the extrusion and bracket, refer to the

diagrams and steps below (installation into the right bay is shown, left bay installation is identical).

Install Front Extrusion & Bracket

65 4

DIAGRAM FOR STEPS 1 & 2 DIAGRAM FOR STEPS 3 - 6

X 4 X 2

Installation Guide - DOC. 5664A Rack Mount Kit: ST-RMK •

•

•• 1

Specyfikacje produktu

Marka:	Crestron
Kategoria:	nieskategoryzowany
Model:	ST-RMK
Kolor produktu:	Czarny
Materiał obudowy:	Metal
Wysokość produktu:	44 mm
Szerokość produktu:	483 mm
Głębokość produktu:	128 mm
Waga produktu:	1100 g
Model:	Zestaw do montażu