Instrukcja obsługi Dell PowerEdge SC430
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Dell PowerEdge SC430 (21 stron) w kategorii serwer. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 4 użytkowników na średnio 4.8 gwiazdek
Strona 1/21

Dell™PowerEdge™SC430SystemsUser'sGuide
System Overview
Using the System Setup Program
Technical Specifications
Glossary
Model DCTA
Notes, Notices, and Cautions
Abbreviations and Acronyms
For a complete list of abbreviations and acronyms, see the Glossary.
Information in this document is subject to change without notice.
©2005DellInc.Allrightsreserved.
Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, the DELL logo, and PowerEdge are trademarks of Dell Inc.; Intel, Pentium, an d Celeron are registered trademarks of Intel Corporation; Microsoft,
Windows, and MS-DOS are registered trademarks and Windows Server is a trademark of Microsoft Corporation; Red Hat is a registered trademark of Red Hat, Inc.; UNIX is a
registered trademark of The Open Group in the United States and other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Dell Inc. disclaims any
proprietary interest in trademarks and trade names other than its own.
Initial release: 6 June 2005
NOTE: A NOTE indicates important information that helps you make better use of your computer.
NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.
CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death.

Back to Contents Page
Technical Specifications
Dell™PowerEdge™SC430SystemsUser'sGuide
Processor
Processor type
Intel®Pentium®D processor with a minimum clock
speed of at least 3.0 GHz
or
Intel Pentium 4 processor with a minimum clock
speed of at least 2.8 GHz
or
Intel Celeron®D processor with a minimum clock
speed of at least 2.53 GHz
Internal cache
At least 2x1 MB (Intel Pentium D processor), 1 MB
(IntelPentium4processor)and256KB(IntelCeleron
processor)
Front-side bus speed
Up to 800 MHz (Intel Pentium D and Intel Pentium 4
processors)and533MHz(IntelCeleronDprocessor)
ExpansionBus
Bus type
PCI and PCIe
Expansion slots
PCIe
2.5-Gb/sec PCIe x1, 3.3-V, 12- V (slot 1)
2.5-Gb/sec PCIe x8, 3.3-V, 12- V (slot 2)
2.5-Gb/sec PCIe x4, 3.3-V, 12- V (slot 4)
PCI
Two 5-V, half-length, 32-bit, 33-MHz (slots 3 and 5)
Memory
Architecture
72-bit, ECC, PC-4300, Unbuffered, DDR II SDRAM,
DIMMs, rated for 533-MHz operation
Memory module sockets
Four 240-pin
Memory module capacities
256 MB, 512 MB, or 1 GB
Minimum RAM
256 MB (one 256-MB module)
Maximum RAM
4 GB
Drives
Hard drives
SATA
SCSI
Up to two non–hot-plug, 1-inch, internal SATA hard
drives with the integrated SATA controller
or
Up to two non–hot-plug, 1-inch, internal SCSI drives
with a SCSI controller card
Diskette drive
One optional 3.5-inch, 1.44-MB
CD drive
One optional IDE CD, DVD, or CD-RW/DVD
combination
NOTE: DVD devices are data only.
Tape drive
One optional 5.25-inch SCSI or IDE tape device
Connectors
Externally accessible

Back to Contents Page
Back
NIC
RJ-45 (for integrated 1-Gigabit NIC)
Serial
9- -pin, DTE, 16550 compatible
USB
Five 4-pin, version 2.0
Video
15- pin VGA
Front
USB
Two 4-pin, version 2.0
Internally accessible
IDE channel
40-pin
SATA channels
Four 7-pin
Video
Video type
Integrated
Video memory
8 MB
Power
AC power supply (per power supply)
Wattage
305 W
Voltage
115–230 VAC, 60/50 Hz, 9.0- 4.5 A
Heat dissipation
1040 BTU/hr maximum
Maximum inrush current
Under typical line conditions and over the entire
system ambient operating range, the inrush current
may reach 140 A for 10 ms or less
Batteries
System battery
CR 2032 3.0-V lithium ion coin cell
Physical
Height
44.5 cm (17.5 inches)
Width
16.76 cm (6.6 inches)
Depth
45.7 cm (18 inches)
Weight (maximum configuration)
17.24 kg (38 lb)
Environmental
Temperature
Operating
10°to35°C(50°to95°F)
Storage
– –40°to65°C( 40°to149°F)
Relative humidity
Operating
8% to 85% (noncondensing) with a maximum
humidity gradation of 10% per hour
Storage
5% to 95% (noncondensing)
Maximum vibration
Operating
0.25 G at 3–200 Hz for 15 min
Storage
0.5 G at 3–200 Hz for 15 min
Maximum shock
Operating
One shock pulse in the positive z axis (one pulse on
each side of the system) of 41 G for up to 2 ms
Storage
Six consecutively executed shock pulses in the
positive and negative x, y, and z axes (one pulse on
each side of the system) of 71 G for up to 2 ms
Altitude
Operating
– –16 to 3048 m ( 50 to 10,000 ft)
Storage
– –16 to 10,600 m ( 50 to 35,000 ft)
Specyfikacje produktu
Marka: | Dell |
Kategoria: | serwer |
Model: | PowerEdge SC430 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Dell PowerEdge SC430, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje serwer Dell
19 Lutego 2025
6 Lutego 2025
8 Grudnia 2024
7 Grudnia 2024
7 Grudnia 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
Instrukcje serwer
- serwer EMC
- serwer Sonnet
- serwer NEC
- serwer Lindy
- serwer Tripp Lite
- serwer HGST
- serwer Toshiba
- serwer Synology
- serwer Abus
- serwer Vimar
- serwer Linksys
- serwer Gigabyte
- serwer Acer
- serwer Teo
- serwer QNAP
Najnowsze instrukcje dla serwer
9 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
28 Marca 2025
28 Marca 2025
28 Marca 2025
10 Marca 2025
10 Marca 2025
10 Marca 2025