Instrukcja obsługi Festo VMPA14-HS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Festo VMPA14-HS (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 7 użytkowników na średnio 4.9 gwiazdek

VMPA...-HS

Vertical pressure shut-off plate

Festo SE & Co. KG

Ruiter Straße 82

73734 Esslingen

Deutschland

+49 711 347-0

www.festo.com

Assembly instructions

8150088

2021-08a

[8150090]

Translation of the original instructions

© 2021 all rights reserved to Festo SE & Co. KG

1

Applicable documents

All available documents for the product

è

www.festo.com/sp.

2Safety

2.1Safety instructions

–

Only use the product in its original condition without unauthorised modifica-

tions.

–Only use the product if it is in perfect technical condition.

–

Before working on the product, switch off the compressed air supply and lock it

to prevent it from being switched on again.

2.2Intended use

The vertical pressure shut-off plate enables replacement of a valve under oper-

ating pressure.

2.3

Training of qualified personnel

Work on the product may only be carried out by qualified personnel who can

evaluate the work and detect dangers. The qualified personnel have knowledge

and experience in pneumatics.

3Additional information

–

Contact the regional Festo contact if you have technical problems

è

www.festo.com.

4Product Range Overview

4.1Scope of delivery

1

2

3

4

Fig.1

1

Vertical pressure shut-off plate (1x)

VMPA...-HS

2

Washer (2x)

3

Distance piece (2x)

4

Fibre optic cable extension (1x)

4.2Not in scope of delivery

5

Fig.2

5

Solenoid valve

VMPA...-M1H-…-PI

5Assembly

5.1Preparation

4

6

Fig.3

•Push the fibre optic cable extension onto the electronics module .46

5.2Assembly

1

2

3

7

8

Fig.4

1.

Check that the conical ring seal is positioned correctly.7

Ä

The tapered side is at the bottom

2.

Place the vertical pressure shut-off plate on the electronics module .18

3.

Place the washers in the lateral slots with the rounding outwards.2

4.

Tighten the distance pieces . Observe the tightening torque.3

Vertical pressure shut-

off plate

Spanner size of the dis-

tance pieces

Tightening torque

VMPA1-HS 20.4 Nm ± 10 %ß

VMPA14-HS 20.5 Nm ± 20 %ß

1

5

9

10

Fig.5

1.Check that the conical ring seal is positioned correctly on the solenoid9

valve .5

Ä

The tapered side is at the bottom

2.

Place the solenoid valve on the vertical pressure shut-off plate .51

3.Tighten the screws . Observe the tightening torque.aJ

Solenoid valveScrewTightening torque

VMPA1-M1H-...U-PIM2x400.25 Nm ± 10 %

VMPA1-M1H-...-PIM2x430.25 Nm ± 10 %

VMPA14-M1H-...-PIM2.5x450.65 Nm ± 10 %

Specyfikacje produktu