Instrukcja obsługi Fluke SBP3

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fluke SBP3 (2 stron) w kategorii Akumulator. Ta instrukcja była pomocna dla 21 osób i została oceniona przez 2 użytkowników na średnio 5.0 gwiazdek

FLK-TI-SBC3B

Charging Base/Power Supply with Adapters

Instruction Sheet

The Fluke FLK-TI-SBC3B Charging Base/Power Supply with Adapters charges the Fluke

FLK-TI-SBP3B Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3B consists of a

charging base, power supply, and power outlet adapters.

PN 4352179 May 2013

© 2013 Fluke Corporation. All rights reserved.

All product names are trademarks of their respective companies. Specications are subject to change without notice.

Safety Information

Use the FLK-TI-SBC3B only as specied in this instruction sheet or other Fluke

product-specic manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3B.

A Warning identies hazardous conditions and procedures that are dangerous to the user.

A Caution identies conditions and procedures that may cause damage to the Product or

the equipment under test.

W Warning

To avoid injury:

●Do not disassemble or short circuit the battery pack.

●Do not expose the battery pack to temperatures above 50 °C (122 °F).

●Do not incinerate or mutilate the battery pack.

●Use only ac adapters approved by Fluke for the product to charge the battery or

power the product.

Table 1. Symbols

Symbol Description

PConforms to requirements of European Union and European Free Trade Association.

"Imager connected to battery charger.

;Conforms to relevant Australian standards.

)Conforms to relevant Canadian and US standards

WImportant information. See manual.

~ This product complies with the WEEE Directive (2002/96/EC) marking requirements.

The afxed label indicates that you must not discard this electrical/electronic product in

domestic household waste. Product Category: With reference to the equipment types

in the WEEE Directive Annex I, this product is classed as category 9 “Monitoring and

Control Instrumentation” product. Do not dispose of this product as unsorted municipal

waste. Go to Fluke’s website for recycling information.

Charging the Battery

Before using the battery pack for the rst time, charge the battery in the two-bay charging

base for at least two and one-half hours. For complete charging instructions, see the

Thermal Imagers User Manual.

Specications

See Table 2 for the specications.

Table 2. Specications

Battery Charging10-15 Vdc 2 A or charge battery pack in Imager with included ac

adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.

Charging / Power LED

StatusCharging LEDPower LED

offno battery detectedno dc power input

solid greenchargeddc power present

blinking greenchargingna

blinking redfaultna

Dimensions 159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)

Operating Temperature-10 °C to 70 °C (-14 °F to 158 °F)

Storage Temperature-20 °C to 80 °C (-4 °F to 176 °F) without batteries

Humidity Range10 % to 95 % non-condensing

Specyfikacje produktu