Instrukcja obsługi Fusion CS-AT1100

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fusion CS-AT1100 (2 stron) w kategorii subwoofer. Ta instrukcja była pomocna dla 42 osób i została oceniona przez 6 użytkowników na średnio 4.7 gwiazdek

ACTIVE TUBE

SPECIFICATIONS

CS-AT1100

PeakPower(Watts)360

RatedPower(Watts)120

FrequencyResponse36Hz-250Hz

LowPassFilter(Variable)40Hz-250Hz

TuningBassReex

WooferSize10”

Fuse20A

Dimensions(mm)559(l)x306(w)x306(h)

22-1/32x12-1/16x12-1/16”

CS-AT1100

www.fusionelectronics.com

CONTROL DESCRIPTIONS

LEVEL

Thisallowstheadjustmentoftheamplierlevelofthesubwoofer.

Turnclockwisetoincreasethelevel.Ifthesoundbecomesdistorted

reducethelevel.

LOW PASS FILTER (LPF)

ThisallowstheadjustmentofthehighestfrequencytheActive

Tubewillproduce.Thisshouldbeadjustedtoblendwithyourmain

speakers.Typically,thiswillbesettoaround100Hz(approximately

thecentralpositionofthecontrolknob).

REMOTE LEVEL CONTROLLER

Whenconnected,thisallowsfurthercontroloverthelevelfroma

remotelocation,usingthesuppliedlead.

INSTALLATION

MakesuretheActiveTubeisrmlyxedinyourvehicle.Check

beforedrillingorcuttingholes.DONOTworkneargastanks,fuel

lines,hydrauliclinesorelectricalwiring.

DONOTmounttheActiveTubeinsuchawayastopinchordamage

thewires.

Makesureeverythingisrmlyconnected,beforeattachingthe

+12Vwire.Ensurethe+12Vwireisfusedascloseaspossibletothe

battery.Alwaysuseafusewiththerecommendedrating.

DISCLAIMER

AlwaysensuretheActiveTubeissecurelyattached,toavoidmovement.FUSIONacceptsnoresponsibilityfordamageorinjuryinrelation

toinappropriatesecuringofthisproduct.

WIRING

•Connectthegroundwiretothevehiclerst(cleandirtandpaint

tobaremetal).

•Connecttheremoteon(bluewire).

•ConnecttheRCAcablesifapplicable,OR

•Connectthespeakerlevelwirebysplicingintotheheadunits

speakerwires.SeeNote1onreverse.

•Connecttheremotelevelcontrollerwiththesuppliedlead.

•Connectthe12volt(redwire)tothepositivebatteryterminal.

•Checkallconnections.

Specyfikacje produktu