Instrukcja obsługi GE JD630DTWW
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla GE JD630DTWW (8 stron) w kategorii piec. Ta instrukcja była pomocna dla 16 osób i została oceniona przez 8.5 użytkowników na średnio 4.8 gwiazdek
Strona 1/8
BEFORE YOU BEGIN
Read these instructions completely and carefully.
• IMPORTANT — Save these
instructions for local inspector’s use.
• IMPORTANT — Observe all governing
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with consumer.
• Note to consumer – Keep these
instructions for future reference.
• Skill level – Installation of this appliance
requires a qualified installer or electrician.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is
not covered under warranty.
FOR YOUR SAFETY:
If you did not receive an anti-tip bracket with your purchase,
call 1.800.626.8774 to receive one at no cost. (In Canada,
call 1.800.561.3344.) For installation instructions of the bracket,
visit: .)GEAppliances.com. (In Canada, GEAppliances.ca
Installation Instructions
30” Electric Drop-In Ranges
MATERIALS YOU MAY NEED TOOLS YOU WILL NEED
1 REMOVE PACKAGING MATERIALS
Failure to remove packaging materials could result in damage to the appliance. Remove all packing
parts from oven, racks, and heating elements. Remove protective film and labels on the outer door
and control panel. Also remove plastic on trims and panel and all tape around the oven. Open oven
door and remove literature pack and oven racks. Remove the bottom trim from the side of the oven.
It will be installed at the end of the installation process. The trim is wrapped separately in a plastic
bag which will also contain the 4 screws to secure the bottom trim and the 2 shoulder screws used
to secure the product to the cabinet.
Questions? Call 1.800.GE.CARES (1.800.432.2737) or visit GEAppliances.com
In Canada, call 1.800.561.3344 or visit GEAppliances.ca
2 PREPARE THE OPENING (FOR INDOOR USE ONLY)
NOTE: Drop-In Ranges are designed to hang from the countertop only. Do not install on a platform
or sup port rails.
WARNING
Before
beginning the installation, switch power
off at service panel and lock the service
disconnecting means to prevent power
from being switched on accidentally.
When the service disconnecting means
cannot be locked, securely fasten a
prominent warning device, such as a
tag, to the service panel.
• child or adult can tip the range and be killed.A
• Install the anti-tip bracket to the wall or floor.
• Engage the range to the anti-tip bracket by sliding the
range back such that the foot is engaged.
• Re-engage the anti-tip bracket if the range is moved.
• Failure to do so can result in death or serious burns
to children or adults.
Tip-Over Hazard
WARNING
• Junction Box
• Wire Nuts
• Strain Relief Clamp for 1/2” Conduit
Oven
Anti-Tip Bracket
Countertop or
Wood Block
Rear
Wall
• 1/8” Drill Bit and
Electric Drill
• Phillips Screwdriver
• Level
• Flathead Screwdriver
• Tape Measure
• 1/4” Nut Driver
• Straight edge or
Square
• Hammer
• Hand or Saber Saw
• Pencil
• Safety Glasses
Allow 30” minimum clearance between surface units and
bottom of unprotected wood or metal cabinet. Allow a 24”
minimum when bottom of wood or metal is protected by no
less than 1/4” thick flame retardant millboard covered with
not less than No 28 MSG sheet metal (.015”), .015” thick
stainless steel, .024” aluminum or .020” copper.
Overall Depth
23 1/2”
Specyfikacje produktu
| Marka: | GE |
| Kategoria: | piec |
| Model: | JD630DTWW |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z GE JD630DTWW, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje piec GE
19 Września 2024
19 Września 2024
31 Maja 2024
29 Maja 2024
29 Maja 2024
29 Maja 2024
28 Maja 2024
28 Maja 2024
28 Maja 2024
28 Maja 2024
Instrukcje piec
- Balay
- Ikea
- Glem Gas
- Bush
- Franke
- LERAN
- Cylinda
- Silverline
- Avanti
- Rex
- Küppersbusch
- Kenmore
- Superiore
- Bestron
- Campingaz
Najnowsze instrukcje dla piec
28 Października 2024
28 Października 2024
28 Października 2024
28 Października 2024
28 Października 2024
27 Października 2024
21 Października 2024
16 Października 2024
13 Października 2024
12 Października 2024