Instrukcja obsługi Halifax FTFHP1030
Halifax
Okap wyciągowy
FTFHP1030
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Halifax FTFHP1030 (4 stron) w kategorii Okap wyciągowy. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5.5 użytkowników na średnio 5.0 gwiazdek
Strona 1/4
Revised 10/2019
Receiving and Storage
Once equipment is received, check for both obvious and hidden damage. If damage is found, record all
necessary informaon on the bill of lading and le a claim with the nal carrier. Check to be sure that
all parts of the shipment, including accessories, are accounted for.
UNPACKING
Verify that all required parts and the correct quanty of each item have been received. If any items are
missing, report shortages to your representave to obtaining missing parts. Somemes it is not possi-
ble that all items for the unit be shipped together due to availability of transportaon and truck space.
Conrmaon of shipment(s) must be limited to only items on the bill of lading. Filters are typically
shipped in the hood, but somemes are shipped on a separate skid in their original packaging. Do not
remove factory packaging or install lters unl just prior to commissioning. Remove all other shipping/
packing materials.
WARNING!!
Installaon of this unit should only be performed by a qualied professional.
Please read the instrucons thoroughly before installing or servicing this equipment.
LISTING
This hood is listed to ANSI UL710 and CAN/ULC S646-10 and built to the “NFPA 96” Naonal Fire
Protecon Associaon Standard
WARRANTY
This equipment is warranted to be free from defects in materials and workmanship, under normal use
and service, for a period of 24 months from date of shipment – See full Installaon Instrucons for
Details.
INSTALLATION
It is necessary to install and operate this unit with the airow (CFM) designed for the size of hood,
lters and installaon based on the informaon provided.
SITE PREPERATION
1. To safely li equipment into the nal installed posion you must make sure the area of installaon
is clear. Make sure you have enough room aer installaon to service unit easily.
2. Verify the locaon that the hood will be installed so there is
nothing to interfere when installing
the unit.
3. Review your plans and specicaons for your project.
4. Conrm and verify the supports will support the weight of the
hood and fan mounted on top of the truck.
5. If installing light xtures
a. Have electrician following wiring diagram as noted in full
Installaon Manual
6. Weld Duct connecon on top of Hood at area which does not
interfere with bracing inside truck
7. Cut hole in Hood at duct connecon – See Figure #1, Item #7
8. To cut the hole properly in the roof of truck – See Figure #1
a. Li hood in the locaon where it will be mounted, ensuring
there is adequate room available to install the hood and all
ductwork to comply with proper clearances from combusble
material (Item # 1)
b. Bring duct in contact with top of truck (Item # 5)
c. Mark locaon of duct on truck roof
d. Lower hood back down
e. Cut hole in roof of truck (Item # 7)
9. Mount Roof Curb with Curb plate on top of truck
(Items # 3 & 4)
10. See aached instrucons for using Concession Hood Bolt Kit to
complete hood aachment
11. Curb Plate securing
a. Cut Curb Plate hole where duct meets plate to ensure ght t
b. Secure Curb Plate to top of Roof Curb
12. Install and secure fan on top of Roof Curb (Item # 2)
13. Wire power to Fan
14. Use Sealant around roof curb and any holes which were made during the installaon process
IMC, NFPA96 and local authories having jurisdicon may call for a minimum clearance (typically
18 inches for type 1, grease rated hoods) between the cooking hood(s), exhaust ducts, and building
materials which are combusble. However, IMC and NFPA96 do outline acceptable clearance
reducon methods; most local jurisdicng authories will accept the clearance reducon methods
approved in the manufacturer’s UL lisng for Type 1, grease rated hoods.
Specyfikacje produktu
| Marka: | Halifax |
| Kategoria: | Okap wyciągowy |
| Model: | FTFHP1030 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Halifax FTFHP1030, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Okap wyciągowy Halifax
11 Stycznia 2025
23 Września 2024
21 Września 2024
21 Września 2024
20 Września 2024
19 Września 2024
18 Września 2024
18 Września 2024
18 Września 2024
17 Września 2024
Instrukcje Okap wyciągowy
- Okap wyciągowy Kluge
- Okap wyciągowy Zanussi
- Okap wyciągowy K&H
- Okap wyciągowy Silverline
- Okap wyciągowy De Dietrich
- Okap wyciągowy Rommer
- Okap wyciągowy Caple
- Okap wyciągowy Trade-Wind
- Okap wyciągowy Eico
- Okap wyciągowy Siemens
- Okap wyciągowy Ariston Thermo
- Okap wyciągowy Ignis
- Okap wyciągowy Eudora
- Okap wyciągowy Friac
- Okap wyciągowy Monogram
Najnowsze instrukcje dla Okap wyciągowy
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025