Instrukcja obsługi Hotpoint FETC70BP
Hotpoint
Suszarka bębnowa
FETC70BP
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hotpoint FETC70BP (4 stron) w kategorii Suszarka bębnowa. Ta instrukcja była pomocna dla 20 osób i została oceniona przez 10.5 użytkowników na średnio 4.5 gwiazdek
Strona 1/4
Instruction booklet
TUMBLE DRYER
Step 1
Open the door of your dryer.
Step 2
Pull out the filter (using the two
finger grips).
Step 3
Clean the fluff off the filter and
replace it correctly.
Step 4
Make sure the filter is pushed fully home - NEVER
run the dryer without the filter in position.
Failure to clean the filter after EVERY drying cycle
will affect the drying performance of your machine.
It will take longer to dry and as a result will use
more electricity during drying.
Step 1
Open the condenser cover.
Step 2
Remove the condenser by turning
the 3 catches and
pulling the condenser
towards you. It is normal for some
residual water to be left in the
condenser unit.
Step 3
Flush the condenser
from the rear with water to remove
any fluff deposits.
Step 4
Replace the condenser unit and
make sure that all 3 catches are
closed and that the position arrows
on the front of the condenser are
pointing upwards.
2
1
Less than 1m
This symbol reminds you to read this booklet
WHERE TO INSTALL THE TUMBLE DRYER
Install the dryer far from gas
ranges, stoves, radiators or
hobs as flames may damage
it. If the dryer is installed
below a worktop, ensure
there are 10 mm between
the upper panel of the dryer
and any objects above it and
15 mm between the sides of
the machine and the walls or
furniture units adjacent to it. This ensures adequate
air circulation.The appliance must be installed with
the rear surface placed against a wall.
! We do not recommend that the dryer is installed
in a cupboard but the dryer must never be installed
behind a lockable door, a sliding door or a door
with a hinge on the opposite side to that of the
dryer door.
Priming the Water Collection System.
When your dryer is new, the water container will not collect water
until the system is primed. This will take 1 or 2 drying cycles. Once
primed it will collect water during every drying cycle.
WATER DRAINAGE CONNECTION
If the dryer is installed next to a drain the water can be plumbed into
this drain. This does away with the need
to empty the water container. The height
of the drain must be less than 1m from the
bottom of the dryer. Remove the existing
hose from the dryer and connect it to the
drain (if required add an additional length
of hose).
ELECTRICAL
CONNECTIONS
The socket must be grounded.
! The power cord must be regularly checked. If the
supply cord is damaged it must be replaced by the
manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
BEFORE YOU START USING YOUR DRYER
Once you have installed your dryer and before
you use it clean the inside of the drum to remove
any dust that could have accumulated during
transport.
CONDENSER UNIT
You MUST clean the fluff from the condenser
EVERY month. Failure to clean the condenser
could cause premature failure of your dryer.
Remove the condenser unit regularly (at least
monthly) and clean off any fluff deposits.
WATER CONTAINER
You empty the water container after MUST EVERY
drying cycle. Removing the water container:
Step 1 Pull the water container
towards you and remove it
completely from the dryer.
Step 2 Empty all the water in the
water container.
Step 3 Replace the water container
making sure that it is securely fixed.
2
! Failure to empty the water container will
cause the machine to stop heating and the
load may still be wet at the end of the drying
cycle. The ‘Empty Water’ light will tell you that
the water container needs to be emptied
FLUFF FILTER
You must clean the fluff filter after EVERY drying cycle.
FETC 70
CDN 7000
10
m
m
15 mm
5
15 mm
15 mm
Specyfikacje produktu
| Marka: | Hotpoint |
| Kategoria: | Suszarka bębnowa |
| Model: | FETC70BP |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Hotpoint FETC70BP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Suszarka bębnowa Hotpoint
30 Stycznia 2025
30 Stycznia 2025
14 Stycznia 2025
29 Grudnia 2024
12 Grudnia 2024
12 Grudnia 2024
12 Grudnia 2024
12 Grudnia 2024
12 Grudnia 2024
12 Grudnia 2024
Instrukcje Suszarka bębnowa
- T4223C
- Pelgrim
- Profilo
- Midea
- Electrolux
- CDA
- Insignia
- Mistral
- Prima
- Continental Edison
- Blomberg
- Beko
- Privileg
- MPM
- Neff
Najnowsze instrukcje dla Suszarka bębnowa
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
9 Kwietnia 2025
8 Kwietnia 2025
7 Kwietnia 2025