Instrukcja obsługi InFocus SP-LAMP-078
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla InFocus SP-LAMP-078 (1 stron) w kategorii Lampa. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 5 użytkowników na średnio 4.7 gwiazdek
Strona 1/1

Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:
Lamp Module Replacement Instructions:Lamp Module Replacement Instructions:
SP-LAMP-078
SP-LAMP-078
SP-LAMP-078
SP-LAMP-078SP-LAMP-078
1. Turn off the projector and unplug the power cord.
2. Wait 60 minutes to allow the projector and lamp to cool
thoroughly.
3. Remove the lamp door, located on top of the projector, by
removing the screws on either side of the lamp door,
sliding the door forward and lifting it off.
4. Loosen the captive screws that attach the lamp housing to
the projector.
NOTE: If the projector is installed on a ceiling mount, be
careful not to drop the lamp module once the captive
screws are loosened.
5. Carefully lift the lamp straight up, off of the alignment pins;
being careful not to pinch the lamp connector. Dispose of
the lamp in an environmentally proper manner.
6. Install the new lamp module, aligning the pins properly. Be
careful not to pinch the lamp connector.
7. Tighten the screws. (NOTE: If the pins have not been
aligned properly, the screws will not tighten securely.)
8. Replace the lamp door by (a) aligning the door, (b) sliding
it towards the back and (c) locking it back into place.
9. Replace the lamp door screws and tighten securely.
10. Plug in the power cord and press the Power button to turn
the projector back on.
11. To reset the lamp hour timer, navigate to the Advanced
Menu > Status/Service menu and select Reset Lamp
Hours.
PL939-4800-00
*PL939-4800-00*
NOTES:
Always use the InFocus lamp module designed for your projector model. Using the wrong lamp module may cause premature lamp failure and possible
damage to the projector.
You can order new lamps from www.infocus.com (in select areas), your retailer or your dealer. Only genuine InFocus lamps are tested for use in this
projector. Use of non InFocus lamps may cause electrical shock and fire, and may void the projector warranty. InFocus is not liable for the performance,
safety or certification of any other lamps.
WARNINGS:
The projector uses a high-pressure mercury glass lamp. The lamp may fail prematurely, or it may rupture with a popping sound if jolted, scratched, or
handled while hot. The risk of lamp failure or rupture also increases as the lamp age increases; please replace the lamp when you see the “Replace
Lamp” message.
To avoid burns, allow the projector to cool for at least 60 minutes before you replace the lamp.
Unplug the power cord before replacing the lamp.
Do not drop the lamp module. The glass may shatter and cause injury.
Do not touch the glass surface of the lamp module. Fingerprints can obscure projection sharpness and may cause the glass to shatter.
Be extremely careful when removing the lamp module. In the unlikely event that the lamp ruptures, small glass fragments may be generated. The lamp
module is designed to contain most of these fragments, but use caution when removing it.
Before replacing a ruptured lamp, clean the lamp compartment and dispose of cleaning materials. Wash hands after lamp replacement.
When replacing the lamp while the projector is ceiling-mounted, wear protective eyewear to prevent eye injury.
Hg-Lamp contains mercury. Manage with accordance with local disposal laws. See www.lamprecycle.org
Image
Setup
Status/Service
Basic Menu
Source Info...
Projector Info...
Reset Lamp Hours...
Factory Reset...
Service Code...
Network Info...
( ) Advanced Menu
MDL: IN3124
FW: 1.02
Specyfikacje produktu
Marka: | InFocus |
Kategoria: | Lampa |
Model: | SP-LAMP-078 |
Kolor produktu: | Czarny |
Typ produktu: | Przelewowy ekspres do kawy |
Pojemność zbiornika na wodę: | 0.75 l |
Wbudowany wyłącznik: | Tak |
Moc: | 680 W |
Przyrządza espresso: | Nie |
Przyrządza kawę: | Tak |
Przyrządza cappuccino: | Nie |
Przyrządza latte macchiato: | Nie |
Wbudowany wyświetlacz: | Nie |
Długość przewodu: | 0.7 m |
Wbudowany młynek: | Nie |
System gorącej wody: | Nie |
Typ wkładu kawy: | Kawa mielona |
Pojemność w kubkach: | 6 kub. |
Położenie urządzenia: | Blat |
Typ ekspresu do kawy: | Ręczny |
Zbiornik na kawę: | Dzbanek |
Automatyczne wyłączanie zasilania: | Tak |
Napięcie wejściowe AC: | 220-240 V |
Waga wraz z opakowaniem: | 1150 g |
Lampy: | - W |
Przyrządza caffe crema: | Nie |
Przyrządza gorące mleko: | Nie |
Stopy antypoślizgowe: | Tak |
Wymiary opakowania (SxGxW): | 160 x 155 x 125 mm |
Kompatybilność: | IN3124, IN3126, IN3128HD |
Kompatybilność marki: | Infocus |
Blokada kapania zapobiega kapaniu wody na prasowane ubrania: | Tak |
Przyrządza americano: | Nie |
Przyrządza latte: | Nie |
Wskaźnik poziomu wody: | Tak |
Przyrządza herbatę: | Nie |
Przyrządza gorącą czekoladę: | Nie |
Podświetlony włącznik/wyłącznik: | Tak |
Rodzaj zakrętki: | Pokrywa na zawiasach |
Przyrządza Ristretto: | Nie |
Przyrządza lungo: | Nie |
Żywotność lamp: | 2000 h |
Zbiornik na wodę: | Szkło |
Przyrządza mocha: | Nie |
Przyrządza mleko czekoladowe: | Nie |
Przyrządza orzo: | Nie |
Zdejmowany uchwyt filtra: | Tak |
Żywotność lampy (tryb ekonomiczny): | 3000 h |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z InFocus SP-LAMP-078, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Lampa InFocus
6 Sierpnia 2024
Instrukcje Lampa
- Lampa Artemide
- Lampa Hayward
- Lampa Genaray
- Lampa Carson
- Lampa Crystorama
- Lampa HiKOKI
- Lampa Graypants
- Lampa Topeak
- Lampa Nordride
- Lampa Elgato
- Lampa Gewiss
- Lampa Silverline
- Lampa Adviti
- Lampa Omnilux
- Lampa WiZ
Najnowsze instrukcje dla Lampa
8 Kwietnia 2025
8 Kwietnia 2025
5 Kwietnia 2025
5 Kwietnia 2025
5 Kwietnia 2025
4 Kwietnia 2025
4 Kwietnia 2025
4 Kwietnia 2025
4 Kwietnia 2025
4 Kwietnia 2025