Instrukcja obsługi Kaden KC21

Kaden klimatyzacja KC21

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kaden KC21 (24 stron) w kategorii klimatyzacja. Ta instrukcja była pomocna dla 21 osób i została oceniona przez 11 użytkowników na średnio 3.8 gwiazdek

Pobierz PDF

Strona 1/24

Evaporative Air Coolers

Safety Information

Installation

Commissioning

Classic Evaporative Air Coolers:

KC17 | KC21 | KC27 | KC32

Low Proﬁle Evaporative Air Coolers:

KL16 | KL22 | KL25 | KL28

Models

INSTALLER’S

MANUAL

Kaden Installer's Manual

Evaporative Air Coolers

Warnings and Important Information 5

1. General Guidelines 6

1.1 Unpacking the Cooler 6 ......................................................................................................................................................

1.2 Unloading the Cooler 6 .......................................................................................................................................................

1.3 Cooler Positioning ............................................................................................................................................................ 6

1.4 Weather Proong ............................................................................................................................................................. 6

1.5 Insulation 6 .........................................................................................................................................................................

1.6 Installing Ductwork ........................................................................................................................................................... 6

1.7 System 6 .............................................................................................................................................................................

2. Cooler Service Requirements 7

2.1 Electrical Power Supply to the Cooler 7 .............................................................................................................................

2.2 Water Supply to the Cooler 7 ..............................................................................................................................................

2.3 Installing the Wall Control 7 ................................................................................................................................................

3. Cooler Hardware 8

3.1 Bends and Elbows 8 ...........................................................................................................................................................

3.2 Dampers 8 ..........................................................................................................................................................................

3.3 Fix and Seal the roof ashing .......................................................................................................................................... 8

3.4 Dropper Duct Installation Guidelines 8 ...............................................................................................................................

4. Installation - Low Prole (KL) Series 9

4.1 KL Series Dropper Duct Installation 9 .................................................................................................................................

4.2 Fitting the Winter-Seal 10 ...................................................................................................................................................

4.3 Fitting the KL Series Cooler 10 ...........................................................................................................................................

5. Installation - Classic (KC) Series 11

5.1 KC Series Dropper Duct Installation Specic .................................................................................................................11

5.2 Fitting the Winter-Seal ....................................................................................................................................................11

5.3 Fitting the KC Series Cooler ...........................................................................................................................................11

6. Fitting the Winter-Seal 12

7. Wall Controller Connection 14

7.1 Wiring the Kaden Networker Wall Control 14 .....................................................................................................................

7.2 Wiring the Kaden Manual Wall Control 14 ..........................................................................................................................

TABLE OF CONTENTS

8. Water Connection 15

8.1 Inlet Connection 15 .............................................................................................................................................................

8.2 Tank Water Quality Management. .................................................................................................................................. 15

8.3 Water Drain Connection 15 ................................................................................................................................................

9. Timing & Cooler Functions 16

9.1 Start Up .......................................................................................................................................................................... 16

9.2 Pre-wet 16 ..........................................................................................................................................................................

9.3 Programmable Wall Control Models In AUTO Mode 16 .....................................................................................................

9.4 Tank Water Quality and Replenishment During Operation 16 ............................................................................................

9.5 Shut-down Times ........................................................................................................................................................... 16

10. Dismantling 17

10.1 Removing the Front and Rear Pads 17 ............................................................................................................................

10.2 Removing the Side Pads 17 ............................................................................................................................................

10.3 Dismantling the Framework 17 .........................................................................................................................................

11. Commissioning Checklist 18

11.1 Isolating Switch 18 ............................................................................................................................................................

11.2 Checklist 18 ......................................................................................................................................................................

11.3 What to check if the Fan Motor will not start? 18 ..............................................................................................................

11.4 What to check if the Pump will not start? 18 .....................................................................................................................

12. Exhaust and Ventilation 19

13. Technical Specications 20

14. Technical Support 21