Instrukcja obsługi Kathrein UWS 24

Kathrein przełącznik UWS 24

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kathrein UWS 24 (4 stron) w kategorii przełącznik. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 6.5 użytkowników na średnio 5.0 gwiazdek

Pobierz PDF

Strona 1/4

1 / 4

UWS 24 20550001

Wideband to Quatro Converter

About this Manual

This document is part of the product.

►Read this manual carefully before using the converter

for the ﬁ rst time.

►Keep this document for reference throughout the

service life of the device and pass it on to any new

owner or user.

For the most up-to-date version of this manual, go to

www.kathrein-ds.com.

Keep this manual in a safe place for future

reference and include it with the unit when

passing it on to the next user.

Features

■Converter for converting two wideband signals to four SAT-IF levels

■The use of terminating resistor EMK 03 (order no. 237169) enables the adaptation to the LNB‘s oscillator frequency

(10.40 GHz or 10.41 GHz)

■Power supply via “horizontal low” trunk

■Terrestrial signals in the 5–862 MHz band can be received even when the satellite receiver is switched oﬀ

■Installation on EXR 2508 (order no. 20510095) or EXR 2558 (order no. 20510096) possible using EMU 250 coupler

(order no. 20510044)

■Kathrein Power Saving:

If no receiver is active in a system using Kathrein Power Saving, both the LNB and the converter are switched oﬀ

Scope of Supply

■UWS 24

●Instructions for use for UWS 24

Transport and Storage

►Use the original packaging for transporting the device; store it in a dry place

►Make sure there is no water condensation build-up.

Intended Use

►The device described in this manual is only intended for the installation of satellite reception systems and may only

be installed by trained specialists

►Any other use or the non-observance of these instructions will result in the loss of the warranty and guarantee

►The manufacturer accepts no liability for accidents caused by the user opening the unit

►Opening the unit and attempting to repair it yourself voids all warranty claims

suitable for DVB-T/T2

44,1 63,45

111,5

148

134

205500001

UWS 24

Made in Germany

H Wideband

Conﬁg

V Wideband

Terr.

H low

V low

V high

H high

Open: LNB 10,40 GHz

Term:

18 V 18 V

Wideband - Quatro - Converter

Digital Systems GmbH

LNB

10,4 GHz1

2 / 4

Safety Precautions

Installation Instructions

Risk of damage to property!

Use a coaxial cable with an inner conductor diameter

of 1.2 mm max. and without any burrs. Ensure short-

circuit-free installation.

►Connectors for coaxial cables: 75 Ω RF connectors

(F series) according to EN 61169-24

►Use wood screws (max. Ø 4 mm) for fastening

►May not be installed in damp rooms

►Use recommended accessories only

Max. 2 mm

excess length

Clamping torque

max. 3.4 Nm

(danger of over-

winding)

Diameter

0.6 - 1.2 mm free of burrs

Improper intervention can endanger the electrical safety of the device.

►Do not open or tamper with the unit

►Always disconnect the mains plug from the socket when working on the system

►Ensure adequate clearance: at least 5 cm to all sides

►Ensure free circulation of air to dissipate the heat from the unit

►Do not place any liquid-ﬁ lled items on top of the device

►Do not expose the device to dripping or splashing water

►Admissible ambient temperature: -20 to +55°C

►The device may only be installed in dry indoor areas

►Do not install the device on or against easily combustible material

►The device is intended for wall mounting only! All other installation positions are prohibited

►Comply with the safety regulations set out in the current EN 60728-11 and EN 62368-1 standards

►The equipment must be provided with an equipotential bonding wire (Cu, at least 4 mm

Input level:

To prevent overloading of the inputs, the level must not exceed 80 dBµV per transponder.

For higher input levels (> 80 dBµV) we recommend to use an attenuator (e.g. ERE 01 with 6 dB, order no.

274854).

Observe the oscillator frequency of the LNB:

Wideband feed systems using an oscillator frequency of 10.41 GHz are available on the market. To be able

to use these, screw an EMK 03 terminating resistor onto the “conﬁ g” socket. The change is eﬀ ective imme-

diately.

This is not required when using the Kathrein feed system UAS 582 (order no 20110032.

3 / 4

Example of Use

err.

high

low

18V

20510095

230V~ 50-60Hz 17W

Power

OFF

Saving

H low:

ma x.

800mA

err.

high

low

Power

Saving

20510096

ESD..

ESC..

ESD..

ESC..

KAZ 11/12*

UAS

582

KA Z 12

21810002

KAZ 11

507205

err.

Wideband

Config

Wideband

205500001

high

low

18V

Open: LNB 10,40 G Hz

Term: LNB 10,41 G Hz

Wideband - Quatr o - Converte

Made in Ge rmany

UWS 24 | EXR 2558 | EXR 2508

Technical Data

Type | Order No. UWS 24

205500001

Frequency range Terrestrial SAT

Input MHz 5–862 290–2350

Output MHz 5–862 950–2150

LNB oscillator frequency

Without conﬁ g resistance GHz - 10.40

With conﬁ g resistance GHz - 10.41

Throughloss dB -0.5 0

Max. input level dBµV - 80

Permissible supply voltage on horiz. low V 12–19

Current drain at 18 V mA 150

Max. remote feed current mA 800

Protection class IP 30

Permissible ambient temperature °C -20 to +55

Connections F connectors

Dimensions (W x H x D) mm 159 x 148 x 43

Packing unit/weight pc./kg 1 (10)/0.45

Specyfikacje produktu

Marka:	Kathrein
Kategoria:	przełącznik
Model:	UWS 24
Kolor produktu:	Grey, White
Wysokość produktu:	43 mm
Szerokość produktu:	159 mm
Głębokość produktu:	148 mm
Waga produktu:	450 g
Ilość:	1
Zakres częstotliwości:	5 - 862 MHz
Model:	Rozdzielacz kabli
Złącze(a):	F
Płeć konektora:	Żeńska
Liczba złączy:	9