Instrukcja obsługi Konig VID-TRANS12KNU
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Konig VID-TRANS12KNU (62 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 3.5 użytkowników na średnio 4.9 gwiazdek
Strona 1/62
2.4GHz AUDIO/VIDEO SYSTEM
TRANSMITTER & RECEIVER
MANUAL
ENGLISH
VID-TRANS12KN
1
Important safety precautions:
This equipment generates and uses radio frequency energy and if not installed and
used properly, that is in strict accordance with the manufactures instructions, it might
cause interference to radio and television reception. It has been tested and found to
comply with the provisions of the 1999/5/EC R&TTE directive, which are designed to
provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
1. Reorient the TV/radio antenna.
2. Relocate the Receiver away from the TV/radio receiver.
3. Plug the Receiver into a different wall outlet so that the Receiver is on a different
branch circuit.
4. If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions.
The user is warned that changes or modifications not approved by the manufacturer
could void the user's authority to operate the equipment. Linear radio controls provide
a reliable communications link and fill an important need in portable wireless signaling.
However, there are some limitations which must be observed.
The equipment is required to comply with the provisions of the 1999/5/EC R&TTE
directive. As such, they have limited transmitter power and therefore limited range. A
receiver cannot respond to more than one transmitted signal at a time and may be
blocked by radio signals that occur on or near their operating frequencies. Changes
or modifications to the device may void R&TTE compliance.
Introduction:
This 2.4GHz system is a wireless audio/video transmission system that uses
advanced wireless communication technology to deliver consistently sharp audio and
video up to 80 meters in open area and 30 meters trough walls and ceilings
(depending on environment circumstances).
The PLL circuit controls the strength and quality of the signal by locking it. It also
integrates an UHF remote control extender to allow you to control the audio or video
source from another room using your existing remote controller.
Using this system, you can enjoy greater convenience of audio/video equipment in
many ways.
Package contents:
1x Transmitter 2x 7.5V DC adapter
1x Receiver 2x AV cable
1x IR cable
EN
2
Description transmitter:
Description receiver:
Antenna
IR cable in
AV input
7.5V DC input
Channel switch
Power switch
Power LED
EN
7.5V DC input
Antenna
Channel switch
IR antenna
AV output
Power switch
Power LED
IR sensor
IR-T AV IN
Specyfikacje produktu
| Marka: | Konig |
| Kategoria: | odbiornik |
| Model: | VID-TRANS12KNU |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Konig VID-TRANS12KNU, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje odbiornik Konig
10 Września 2024
4 Września 2024
30 Sierpnia 2024
26 Sierpnia 2024
25 Sierpnia 2024
21 Sierpnia 2024
16 Sierpnia 2024
14 Sierpnia 2024
8 Sierpnia 2024
Instrukcje odbiornik
- odbiornik Vivotek
- odbiornik Hager
- odbiornik Dimavery
- odbiornik Shinybow
- odbiornik Markbass
- odbiornik Esoteric
- odbiornik Bang & Olufsen
- odbiornik Sony
- odbiornik Solid State Logic
- odbiornik Alecto
- odbiornik Anthem
- odbiornik Stinger
- odbiornik Vonyx
- odbiornik EA
- odbiornik Orava
Najnowsze instrukcje dla odbiornik
9 Kwietnia 2025
9 Kwietnia 2025
5 Kwietnia 2025
4 Kwietnia 2025
3 Kwietnia 2025
2 Kwietnia 2025
2 Kwietnia 2025
1 Kwietnia 2025
30 Marca 2025
30 Marca 2025