Instrukcja obsługi Kramer SI-1VGA

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kramer SI-1VGA (2 stron) w kategorii sterownik. Ta instrukcja była pomocna dla 14 osób i została oceniona przez 9 użytkowników na średnio 4.1 gwiazdek

The Kramer SI1VGA- - Stepin Module

Congratulations on purchasing your Kramer SI-1VGA Step-in Modulewhich is ideal for

boardrooms and presentation rooms.

The Kramer VGA and unbalanced stereo audio remoteSI-1VGA is a control panel that

can, for example, the Kramer fit into TBUS-10 Table ConnectionBox(see Figure 3) or

the The K-POD301. Podium Table BusSI-1VGA is used for remotely taking control of

a compatible switcher, for example, the VP-81KSi.

Figure 1 and Table 1define the SI- 1VGA Step-in Module.

Figure SIFront Panel 1: - -1VGA Stepin Module and Rear View

Table SI1: - -1VGA Stepin Module Front and Rear Features

# FeatureFunction

1 VIDEO INPUTVGA 15-pin HD

(F) Connector

Connect to video sourcethe

2 AUDIO INPUT3.5mm Mini

Jack

Connect to nced stereo audio source the unbala

3 STEP INButton Press to switch the input to this remote control panel. LED lights yellow

when active

4 AUDIO OUTPUT 3.5mm Mini

Jack

Connect to unbalanced stereo audio inputthe of the switcher

5 VIDEO OUTPUT VGA 15-pin

HD (F) Connector

Connect to video inputthe of the switcher. (The cable used must connect

all pins, for example, Kramer cable CP-GMA/GMA/XL)

Figure 2 shows the wiring connections of the SI-1VGA.

Figure SI2: - 1VGA Wiring Connections

To install as illustrated in and connect the SI- 1VGAFigure 2:

Note: Theeps assume that you have video (with 15 tfollowing s-pin HD (M)

connectors) and audio (with 3.5mm mini jacks) cables running from the switcher

inputs to the inside of either the TBUS-10 (see Figure 3) or the

K-POD301, depending on which you are using.

1. Connect the video cable in the TBUS- /K-10POD301-to the 15pin HD VIDEO

OUTPUT connector on the rear of the SI-1VGA.

2. Connect the audio cable in the TBUS- /K-10POD301 to the 3.5mm mini jack

AUDIO OUTPUT connector on the rear of the SI-1VGA.

3. . Insert the SI-1VGA into the required cutout of the TBUS--10/K POD301

4. Insert the two screws to secure the module in place and tighten the screws.

5. Plug the video source (for example, a computer) into the 15-pin HD VIDEO

INPUT connector on the front panel of the SI- .1VGA

6. Plug the audio source (for example, a computer) into the 3.5mm mini jack AUDIO

INPUT connector on the front panel of SI-1VGA.

7. . Press the STEP IN button to take control of the switcher input

Specyfikacje produktu