Instrukcja obsługi Outdoor Connection Galaxy Plus

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Outdoor Connection Galaxy Plus (2 stron) w kategorii namiot. Ta instrukcja była pomocna dla 44 osób i została oceniona przez 3 użytkowników na średnio 4.5 gwiazdek

QUALITY YOU CAN SEE FEEL AND TRUST

GALAXY PLUS INSTRUCTIONS

1. Select a dry level area and clear the ground of any sharp or dangerous objects.

2. Spread out the floor of the inner tent and peg out the four corners,of the sunroom ensuring that the tent is pulled out firmand square then peg out the 2 outside corners

(be careful not to make it too taut) . Peg out the remaining pegging points. The adjustable straps on some of the peg loops should be set approximately in their middle

position Adjusting(not pulled up tight). all these straps up tight may over stress the inner tent and cause some seams to start separating.

3. Assemble all the fibreglass polesand steel poles .

4. The pole sleeves are colour coded to the fibreglass poles. The 2 black poles go diagonally over the middle of the main tentand insert the ends into the plastic fitting s. 2

yellow poles go through sleeves across the tent at each end. The remaining yellow poles go across the middle of the tent in the same direction as the end poles. Insert

the ends into the plastic fittings and clip the tent to the poles.grey poles go lengthwise across the middle, insert the ends into the plastic fittings and clip the tent to the 2

poles. The remaining grey pole goes through the pocket in the end of the sa pole through a sleeve at each end of the tent and sunroom unroom. Therebe should now

and a square structure in the middle with diagonal poles.

5. You are now ready to erect the middle section of the tent. One end of the steel poles has a plug with a small hole, this is the bottom. With one person at either side of the

tent lift one side of the middle section and insert apole in the plastic fitting, then fit the lower end over the pin attached to the floor of the tent. Repeat the process for steel

the other side. The middle section of the tent should now be standing.

6. The remaining steel poles can now be fitted using the same process.

7. Attach all tent clips to the upright poles. You are now ready to fit the fly.

8. Position the fly over the tent and align it into place. ie off the fly around the plastic elbows (below the shock cord) at the top of the polestabs on the T.Attach the Velcro

inside of the fly to the poles. Peg out the fly ensuring an adequate gap between the fly and the inner.

9.es. Peg out all the guy rop

10. Finally, fine tune the fly so it remains and positioned correctly over the tent. The adjustment straps at some peg points can be used for small adjustments but make firm

sure that the tent is not too tight as the tent seams can be damaged

***** *****REVERSE THESE PROCEDURES TO LOWER THE TENT

Packing Instructions:

1.tent Make sure the inner and fly are COMPLETELY DRY and CLEAN before packing away.

2.and Fold the fly in half lengthwise and fold the ends in to fm a rectangle. Then fold each end into the middle orcontinue folding until you have a long rectangle approx

80cm wide and 250cm long. The bottom of the fly should be at one end.

3. Fold the sunroom othe inner tent over onto the main tent. Fthe inner tent into quarters lengthwise by folding both sidesinto the centre, then one half over the other.f old

4. Lay the fly on top of the inner and tightly roll up the tent (rolling towards the bottom edge of the fly which helps to push the air out)

5. Secure the rolled up tent with the supplied ties.

6. Place in carry bag.

7. Pack the poles and pegs into their separate bags.

www.outdoorconnection.com.au

Specyfikacje produktu