Instrukcja obsługi P3 International P0270

P3 International Sprzęt pomiarowy P0270

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla P3 International P0270 (8 stron) w kategorii Sprzęt pomiarowy. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 6 użytkowników na średnio 5.0 gwiazdek

Pobierz PDF
Strona 1/8
Mold Alert
........................................................
Operation Manual
P0270
Congratulations on your purchase of the P0270 Mold Alert!
Mold is as old as the Earth and it’s everywhere. Under the right set of
conditions, it can actually start to grow inside your home. Some types
of mold even contain mycotoxins (toxins produced by fungus-type
organisms) which can be hazardous to your health.
Mold can grow at humidity levels over 65%. If you keep the relative
humidity in your home below 50%, mold growth can be inhibited. The
Mold Alert Thermo-Hygrometer allows you to monitor some of the key
factors in the home that can lead to mold, dust mites, and bacteria.
INTRODUCTION
FEATURES
● AudibleandVisualalarmfunctiontoindicateriskofmold
● RoomTemperature
● IndoorRelativeAirHumidity
● DewPoint
● MaximumandMinimumvalues
● On/Offswitchforaudioalarm
OVERVIEW
The interaction of temperature and air humidity:
Cold air absorbs little or no moisture. When this air enters living areas
it becomes warmer and can then absorb much more water vapor. This
interdependency of temperature and relative humidity is expressed by
means of the dew-point.
If the measuring unit indicates an air temperature of 68°F and a
relative humidity of 65%, then the dew-point temperature will be 56°F.
What does this mean? That the air, in your bedroom for instance, will
condense and form water droplets on surfaces that are cooler than
56°F, and these damp areas may lead to mold.
STARTUP
OVERVIEW
If the air is at a relative humidity of 40%, then the dew-point
temperature is only 43°F. The walls and ceilings would therefore have
tobesignicantlycolderfortheairtoreachitsdew-pointandforwater
droplets to form.
How to achieve the correct temperature and air humidity:
Tips for active heating and ventilation:
● Checkthedew-point!Surfacesofwallsshouldnotfallbelowa
temperature of 59°F.
● Avoidshuttingofftheheatcompletelywhenleavingthehousefor
extended periods of time.
● Ventilateinallweatherconditions,evenifit’sraining.
● Openthewindowsforashorttimetoairtheroom.Apartially
opened window does not have the desired effect, wastes heating
energy and can even promote the formation of mold.
● Iftheroomairistoodry,particularlyinthewinter,thenelectrical
airhumidiersarerecommended,sinceairingatlowtemperatures
will tend to decrease the humidity further.
● Whenairingaroom,afewminutesshouldbesufcient.Check
the value indicated on your Mold Alert thermo-hygrometer.
1. Select°F/°Candplacetheaudioalarmswitchonthebackofthe
unit in “on” mode.
2. Slideofffrontcompartmentandinstall2batteries1.5VAA.Once
these are in place, the frowning face on the display will light up
brieyandthealarmwillsoundfor2seconds.
3. Replacebatterycompartmentcover.
4. Removetheprotectionlmonthedisplay.
5. The unit is now ready to use.

Specyfikacje produktu

Marka: P3 International
Kategoria: Sprzęt pomiarowy
Model: P0270

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z P3 International P0270, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Sprzęt pomiarowy P3 International

P3 International

P3 International P0270 Instrukcja

29 Września 2024

Instrukcje Sprzęt pomiarowy

Najnowsze instrukcje dla Sprzęt pomiarowy

Uni-T

Uni-T UT220 Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT681C Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT216C Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT611 Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT210D Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT210C Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT210B Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT682 Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT275 Instrukcja

3 Kwietnia 2025
Uni-T

Uni-T UT08A Instrukcja

3 Kwietnia 2025