Instrukcja obsługi Panduit NK5E88MBUY

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Panduit NK5E88MBUY (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 5 użytkowników na średnio 4.4 gwiazdek

N KET EY

NETWORK COMPONENTS

CONTRACTOR GRADE

For Technical Support: www.panduit.com/resources/install_maintain.asp

INSTALLATION INSTRUCTIONS

© Panduit Corp. 2014NK178C

Page 1 of 2

NetKey Keystone Style Jack Modules

Part Numbers: NK366M**Y, NK388M**Y, NK588M**Y, NK5E88M**Y, NK5E88M**Y-Q

1

2

3

4

5

6

7B

Straighten conductors and arrange in proper color sequence.

Remove 3" (76.2mm) of cable jacket and untwist pairs.

Pull conductors until outer jacket is inside cap. Bend up 90°. Cut conductors on an angle and insert into cap.

Snap cap squarely on housing until it clicks.Trim conductors flush with cap using wire snipping tool (CWST).

NOTE: Cable jacket is inside the cover.

Use Snap Tool (7A) or standard Slip Lock Pliers (7B).

Apply pressure to cap until it clicks again. Cap must be flush on

housing.

Termination Cap Removal Instructions

--- FOR USE IN KEYSTONE STYLE OUTLETS AND PATCH PANELS ONLY ---

--- OVER FOR KEYSTONE STYLE PANEL OPENING REQUIREMENTS ---

Slide screwdriver under cap to separate from housing.Push forward and down against latch at end of guide ramp until cap releases.

1

2

7A

** Denotes jack module color code.

Specyfikacje produktu