Instrukcja obsługi Peavey RBN 215
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Peavey RBN 215 (20 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 40 osób i została oceniona przez 20.5 użytkowników na średnio 5.0 gwiazdek
Strona 1/20
www.peavey.com
RBN™ 215 SUB
Powered Speaker System
Operating
Manual
FCC/ICESCompliancyStatement
This Standard(s). device complies with Part 15 of the RSS FCC rules and Industry Canada license‐ exempt Operation is
subject following harmful interference, andtothe twoconditions:(1)thisdevicemaynotcause (2)thisdevicemust
accept any interference may operation. received, that cause undesired
Le conforme deprésent est appareil aux CNR Canada d’lndustrie applicables aux appareils radio exempts
licence. est autoriséeL’exploitation aux deux conditions suivantes: (1) I’appareil ne dedoit pas produire
brouillage, (2) I’utilisateur I’appareil brouillage leet de doitacceptertout radioélectriquesubi,mêmesi
brouillage susceptible fonctionnement.est d’encompromettrele
Warning: Changes or modifications to the equipment not approved by Peavey Electronics Corp. can void the
user’s authority to use the equipment.
Note – This equipment has been tested and found to comply with the limits for a Class Bdigital device,
pursuant to Rules. limits to provide reasona protection against Part15oftheFCC These aredesigned ble
harmful in a residential installation. generat uses, and radiointerference Thisequipmentes, canradiate
frequency energy and, if installed and in accordance with t instructions, harmful not used he maycause
interference to dio However, ra communications. thereis gua that interference will occur in anorantee not
particular rainstallation.If this equipment does cause harmful interference to dio television reception,or
which turning equipment and t is to andcanbedeterminedby the off on,heuser encouraged try correctthe
interference followingbyoneormoreofthe measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Caution
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
Introduction
ank you for purchasing the Peavey® RBN™215 Sub powered speaker system. e RBN™215 Sub features a
dual power section that provides 1000 watts of peak power for each woofer for a total of 2000 watts of peak
power, all with DDT™ compression. Featuring two 15” Low Rider™ woofers in a compact enclosure, the
RBN™215 Sub provides two mixed input channels, each with Gain control and a mic/line gain switch, and each
channel features a combo jack with 1/4” TRS & female XLR and a balanced input with volume control. A DSP
based crossover and processor provides extreme exibility to the user faced with common location acoustics
conditions.
Features
• Vented bass powered subwoofer enclosure
• 2000 watts peak dynamic power
• Dual 15” Peavey® exclusive Low Rider™ Woofers
• Peak SPL up to 133 dB with music!
• Power Amp has forced air cooling for maximum reliability
• Powerful yet precise DSP based crossover network and speaker processing
• 24 bit ADC/DAC, 96 kHz sample rate, 32 bit xed point DSP
• Two independent mixed channels with XLR/one quarter inch combo jack inputs
• Input 2 has a 3.5 mm (1/8”) stereo media input jack
• Two XLR outputs, One High-Pass, One Full Range ru
• Large Heavy-Duty Locking Casters with damped bearings
• Full-coverage heavy-duty perforated steel grill
• Tough 18 mm birch plywood construction with internal bracing
• Two Pairs of Steel handles
• Compact dimensions for a dual 15” woofer based sub
• readed Pole Mount with speaker pole included
• Peak SPL up to 133 dB with music!
Applications
e Peavey RBN™ 215 Sub has a variety of applications such as extending the bass performance of smaller full-
range speaker systems used for sound reinforcement, public address, side ll system, karaoke or musical play-
back.
A typical signal source for the line-level inputs of the Peavey RBN™ 215 Sub would be a sound reinforcement
mixing console (mixer) or the output from a CD player, MP3 player or tape deck. e high-pass ltered signal
from the RBN™ 215 Sub would then be sent to a full-range powered speaker system, easing the burden of deep
bass from this speaker system.
ENGLISH
Specyfikacje produktu
| Marka: | Peavey |
| Kategoria: | głośnik |
| Model: | RBN 215 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Peavey RBN 215, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje głośnik Peavey
30 Grudnia 2025
3 Października 2024
24 Września 2024
17 Września 2024
15 Września 2024
15 Września 2024
14 Września 2024
11 Września 2024
11 Września 2024
8 Września 2024
Instrukcje głośnik
- głośnik Arctic Cooling
- głośnik Fenton
- głośnik PS Audio
- głośnik Boompods
- głośnik EARISE
- głośnik Klipsch
- głośnik S-Digital
- głośnik Turbosound
- głośnik JAZ Audio
- głośnik Marshall
- głośnik Andover
- głośnik Kenwood
- głośnik Adam Hall
- głośnik Delvcam
- głośnik BSS Audio
Najnowsze instrukcje dla głośnik
8 Kwietnia 2025
8 Kwietnia 2025
8 Kwietnia 2025
7 Kwietnia 2025
7 Kwietnia 2025
7 Kwietnia 2025
5 Kwietnia 2025
3 Kwietnia 2025
3 Kwietnia 2025
3 Kwietnia 2025