Instrukcja obsługi Pioneer DDJ-SX2

Pioneer Sprzęt DJ-ski DDJ-SX2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pioneer DDJ-SX2 (2 stron) w kategorii Sprzęt DJ-ski. Ta instrukcja była pomocna dla 16 osób i została oceniona przez 8.5 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

DJ CONTROLLER

SX2

http://pioneerdj.com/support/

The Pioneer DJ support site shown above offers FAQs, information on software and various other types of

information and services to allow you to use your product in greater comfort.

Firmware Update Guide

Read Before Use <Important>

■Unzip the downloaded update file for updating.

■If Java has not been installed, please download the Java Runtime

Environment (JRE) at: http://java.com and install it on your

computer.

■ASIO driver exclusively for DDJ-SX2 is required to be installed for

Windows PC users.

■If you should have any questions, please contact the Pioneer

Customer Support Center.

Updating Procedures

Note: Turn the power off and disconnect all the cables from the

unit. And close all applications on your computer before running

this updating procedure.

1) Connect your computer to DDJ-SX2 via the USB cable included

with the product.

2) Turn on the power of DDJ-SX2 while pressing the [SHIFT

SHIFTSHIFT

SHIFT] button

and the [SYNC

SYNCSYNC

SYNC] button on the LEFT deck, and ensure the Level

meter LEDs flash before releasing your finger from the these

buttons.

3) After waiting for about 10 seconds when the update file for

DDJ-SX2 (DDJ-SX2_Vxxx.jar) is activated, the following dialogue

is displayed. Click the [Start

StartStart Start] button.

■If an error message is displayed, press the [CloseCloseCloseClose] button to close

the controller and then activate the update file again.

■Approximately a few minutes are required for updating.

4) When the firmware update process is complete, click the [OKOKOKOK]

button.

Note: Please note that if you fail to update, turn on the power of

DDJ-SX2 again and start from Step 2) of the above Updating

Procedures.

How to check the Firmware

Version

========================================

For Windows

From the [Start menuStart menuStart menuStart menu], Run [All All All All PPPProgramsrogramsrogramsrograms] → [PioneerPioneerPioneerPioneer] → [DDJDDJDDJDDJ----SSSSX2X2X2X2]