Instrukcja obsługi Projecta PC800

Projecta Ładowarka baterii PC800

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Projecta PC800 (16 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 24 osób i została oceniona przez 12.5 użytkowników na średnio 3.6 gwiazdek

Pobierz PDF

Strona 1/16

PRO-CHARGE

6 STAGE SWITCHMODE

BATTERY CHARGER

P/No.s PC400, PC800, PC1600, PC2100

IMPORTANT SAFETY INFORMATION

Please read this manual thoroughly before use and store in a safe place for future reference.

WARNING

• Explosive gases may escape from the battery during charging. Prevent flames and

sparks. Provide adequate ventilation.

• Before charging, read the instructions.

• For indoor use. Do not expose to rain.

• For charging 12 Volt lead acid batteries ONLY.

• Disconnect the 240V mains supply before making or breaking the connections to the

battery.

• The battery charger must be plugged into an earthed socket-outlet.

• Connection to supply mains is to be in accordance with National wiring rules.

• Do not attempt to charge non-rechargeable batteries.

• Never charge a frozen battery.

• If the AC cord is damaged do not attempt to use. It must be replaced or repaired by a

qualified person.

• Corrosive substances may escape from the battery during charging and damage delicate

surfaces. Store and charge in a suitable area.

• Ensure all vehicle accessories including lights, heaters, appliances etc are turned off

prior to charging.

• This appliance is not intended for use by young children or infirm persons unless they

have been adequately supervised by a responsible person to ensure that they can use

the appliance safely.

• Young children should be supervised to ensure that they do not play with the appliance.

6-STAGE AUTOMATIC CHARGING

This is a fully automatic battery charger with 6 charge stages.

Automatic charging protects your battery from being overcharged so you can leave the

charger connected to the battery indefinitely.

6-stage charging is a sophisticated charging technique that gives your battery longer life

and better performance compared to using traditional chargers.

Projecta’s Pro-Charge chargers are suitable for most 12V automotive, marine and deep

cycle batteries. They may also help restore drained and sulphated batteries.

The 6 charge stages are:

Rejuvenation; Soft Start; Bulk; Absorption; Battery Test and Float.

REJUVENATION

The rejuvenation stage is manually initiated and delivers a 24 hour high frequency,

intermittent charge that breaks down sulphation from the battery’s plates. Upon

completion, the charger will proceed to Soft Start.

SOFT START

This is a preliminary charge process that gently introduces power to the battery,

protecting the battery and increasing battery life.

BULK (CONSTANT CURRENT)

The Bulk stage reduces charging time by charging the battery at the maximum rate

(constant current) to a set voltage, at which point the battery is approximately 80%

charged.

ABSORPTION (CONSTANT VOLTAGE)

The absorption stage charges the battery to 100% by adjusting the charge rate allowing

the battery to absorb more power.

EQUALISATION (CALCIUM MODE ONLY)

Designed especially for calcium batteries, this stage returns calcium batteries to full

service by removing acid stratification of the electrolyte.

BATTERY TEST

The analysis mode tests the battery to ensure that it has taken the charge; if the

battery passes the test the charger will proceed to the float stage.

FLOAT

The Float stage maintains the battery at 100% charge without overcharging or

damaging the battery. This means the charger can be left connected to the battery

indefinitely.

Specyfikacje produktu

Marka:	Projecta
Kategoria:	Ładowarka baterii
Model:	PC800
Długość przewodu:	1.7 m
Typ wyświetlacza:	LED
Położenie urządzenia:	Wolnostojący
Częstotliwość wejściowa AC:	50 Hz
Napięcie wejściowe AC:	230 V
Wysokość produktu:	850 mm
Szerokość produktu:	450 mm
Głębokość produktu:	600 mm
Kolor drzwiczek:	Stal nierdzewna
Liczba miejsc:	9 komplet.
Funkcja AquaStop:	Tak
Ilość programów piorących:	4
funkcja AquaSensor:	Tak
Poziom hałasu:	47 dB
Opóźniony start czasomierza:	Tak
Opóźniony start:	19 h
Czas cyklu:	140 min
Obciążenie:	2300 W
Pobór wody na cykl:	11 l
Zużycie energii na cykl:	0.8 kWh
Wskaźnik pozostałego czasu:	Tak
Zabezpieczenie przed dziećmi:	Tak
Klasa efektywności energetycznej (stara):	A
Kategoria prania:	A
Światło wewnętrzne:	Nie
Wbudowany zegar:	Tak
Kategoria suszenia:	A
Program szybki:	Nie
Liczba cykli:	4