Instrukcja obsługi QUIO QU-1001-HF

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla QUIO QU-1001-HF (1 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 23 osób i została oceniona przez 7 użytkowników na średnio 4.5 gwiazdek

QU-1001-HF RFID Card Reader

Manual

Specification：

Working Voltage：DC 9V-16V

Static Current≤80mA：

Reading Range510CM： ～

Support :EM-ID or M1card

Ambient Temperature-4070：℃～℃

Ambient Humidity10%90%： ～

International Standard WiegandInterface

Less than 100M Communication Distance

Installation：

Using “+”type screw driver to loosen the screw between the

panel and mother board.And then embed themotherboard

to the side wall with the plastic plug and screws.

Wire Connection：

WG26/34 RS485RS232

Red DC9V-16VRed DC9V-16VRed DC9V-16V： ： ：

Black GND：

Green D0：

White D1：

Blue LED：

Yellow BEEP：

Black GND：

Green 4R+：

White 4R-：

Black GND：

Green RX：

White TX：

gray :GND to wiegand 34

purple: Door Bell

Notice！

1. Confirm the electric voltage (DC12V) and differentiate

positive anode and cathode of power supply

2. When external Power isused, make suresharing the

power with Controller Box or using the same GND

3. The wire connectsreader to controller, advise use8

cores stranded twisted pair cable(among them, three

strands arespare, ifno needreadershow illegalcardsby

sound and light, LED wire can not be used, data wire

Data1 Data0 are twisted pair would be better,

we suggest sectional area are 0.22 square millimeter at

least. The length should not exceed 100meters.

Email: web: kontakt@quio-rfid.de http://www.quio-rfid.de/

Quick-Ohm Küpper & Co. GmbH | Cronenfelderstraße. 75 | 42349 Wuppertal | Tel: +49 (0) 202 404329 | Fax: +49 (0) 202 404350

Specyfikacje produktu