Instrukcja obsługi Shure PA805Z2

Shure nieskategoryzowany PA805Z2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Shure PA805Z2 (4 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 20 osób i została oceniona przez 5 użytkowników na średnio 4.4 gwiazdek

Pobierz PDF

Strona 1/4

IMPORTANT SAFETY INSTRUCTIONS

1.READ these instructions.

2.KEEP these instructions.

3.HEED all warnings.

4.FOLLOW all instructions.

5.DO NOTuse this apparatus near water.

6.CLEAN ONLY withdry cloth.

7.DO NOTblock any ventilation openings. Allow sufficient distances for

adequate ventilation and install in accordance with the manufacturer’s

instructions.

8.DO NOTinstall near any heat sources such as open flames, radiators,

heat registers,stoves,or other apparatus(including amplifiers)that pro-

duce heat. Do not place any open flame sources on the product.

9.DO NOT defeat the safety purpose of the polarized or grounding type

plug. A polarized plug has two blades with one wider than the other. A

grounding type plug has two blades and a third grounding prong. The

wider blade or the third prongare provided for your safety. If the provided

plug does not fit into your outlet, consult an electrician for replacement

of the obsolete outlet.

10.PROTECT thepower cord frombeing walkedon or pinched,particularly

at plugs, convenience receptacles, and the point where they exit from

the apparatus.

11.ONLY USE attachments/accessories specified bythe manufacturer.

12.USE onlywith a cart, stand, tripod, bracket, or table specified bythe

manufacturer,or sold with the apparatus.Whena cart is used, use caution

when moving thecart/apparatuscombination toavoidinjuryfrom tip-over.

13.UNPLUGthis apparatus during lightning storms orwhen unused for long

periods of time.

14.REFER allservicing toqualified service personnel.Servicing isrequired

when the apparatus has been damaged in any way, such as power

supply cord or plug is damaged, liquid has been spilled or objects have

fallen into the apparatus, the apparatus has been exposed to rain or

moisture, does not operatenormally, or has been dropped.

15.DO NOT expose the apparatus to dripping and splashing. DO NOT put

objects filled with liquids, such asvases, on the apparatus.

16.The MAINS plug or an appliance coupler shall remain readily operable.

17.The airborne noise of the Apparatus does not exceed 70dB (A).

18.Apparatus with CLASS I construction shall be connected to a MAINS

socket outlet with a protective earthing connection.

19.To reducethe risk offire or electricshock, do notexpose this apparatus

to rain or moisture.

20.Do not attempt to modify this product. Doing so could result in personal

injury and/or product failure.

21.Operate this product within itsspecified operating temperature range.

Explanation of Symbols

Caution: risk of electric shock

Caution: risk of danger (Seenote.)

Direct current

Alternating current

On (Supply)

Equipment protectedthroughout by DOUBLE INSULATION or

REINFORCED INSULATION

Stand-by

Equipment should not be disposed of in the normal waste stream

WARNING: Voltages in this equipment are hazardous to life. Nouser-ser-

viceable parts inside. Refer all servicing to qualified service personnel. The

safetycertifications do not applywhen the operating voltage is changed from

the factory setting.

WARNING: Thisproduct contains a chemical known to the State of California

to cause cancer and birth defects or other reproductive harm.

General Description

The Shure PA805Z2-RSMA is a passive directional antenna that improves

RF performancebyrejectingoff-axisRFsignal. Positionedremotely,antennas

can be aimed directlyat transmitters.

The antennaattaches to a microphone stand or to the separate wall-mounting

bracket, and delivers the following benefits over standard omnidirectional

half-wave antennas:

•Reduced interference

•Improved RF signal-to-noise ratio

•Antenna gain (8 dBi) helps overcome cable loss

Installation Instructions

1.Determine the lengthof cable required toconnect each antenna to thereceiver or antenna/power distribution system.Use the shortest lengthof cable pos-

sible, because longer cable runs increase power and signal loss.

Important: Only use low-loss reverse SMA cables to prevent signalloss.