Instrukcja obsługi Whirlpool FFT M11 8X3BY EE
Whirlpool
Suszarki do ubrań
FFT M11 8X3BY EE
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Whirlpool FFT M11 8X3BY EE (4 stron) w kategorii Suszarki do ubrań. Ta instrukcja była pomocna dla 34 osób i została oceniona przez 17.5 użytkowników na średnio 4.4 gwiazdek
Strona 1/4
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.whirlpool.eu/register
Policies, standard documentation, ordering of spare parts and additional product information can be found by:
• Using QR code in your appliance
• Visiting our website docs.whirlpool.eu/docs and parts-selfservice.europeanappliances.com
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-sales
Service, please state the codes provided on your product's identification plate.
EN
Before using the appliance carefully
read the Safety Instruction.
PLEASE SCAN THE QR CODE ON YOUR APPLIANCE IN ORDER TO REACH MORE INFORMATION.
Quick guide
Before using the appliance carefully
read the Safety Instruction.
DAILY USE
Doing this will keep your machine working at its BEST:
- remember to empty your water tank after each drying
cycle.
- remember to clean your lters after each drying cycle.
Refer to the Care & Maintenance section.
1. Plug the dryer into the power supply socket.
2. Open the door and load garments; always refer to instructions on
clothing labels and the max loads indicated in the programme
section. Empty pockets. Make sure garments do not get caught
between the door and/or the door filter. Do not load items that
are dripping wet. Do not tumble dry large, very bulky items. For
optimal drying result, garments should be loaded one by one.
3. Close the door.
4. Press the "On/Off" button.
5. Select the most suitable programme
for the type of fabric in
that load.
6. Select the options, if necessary.
7. Press the "
Start/Pause"
button to begin drying.
8. At the end of the drying cycle, a buzzer will beep. An indicator on
the control panel signals the end of the cycle. Turn the machine
off by pressing the "On/Off" button, open the door and pull the
clothing immediately out to prevent the formation of creases on
laundry.
If the machine is not switched off manually, after about a quarter
of an hour from the end of the cycle , the appliance turns off
automatically to save energy.
Note that some models perform a final cool tumble phase, for this
reason the fabrics may not feel hot.
In case of power failure, it is necessary to press the "Start/Pause"
button to restart the cycle
Opening the door during the cycle
The tumble dryer door can be opened at any time during the cycle
to check progress and remove any garments already dry.
However, since opening the door can extend the drying time, the
recommendation is to keep the door closed throughout the cycle
process to save time and energy.
After closing the door, press the "Start/Pause" button within 15
minutes to resume the machine operation.
NOTE: in any case, the drying cycle must be completed to ensure
the condenser auto-cleaning phase is finalized.
CARE LABEL
Always check the care labels, especially when placing garments in
the tumble dryer for the fi rst time. Below are the most commonly
used symbols:
May be tumble dried.
Do not tumble dry.
Tumble dry – high heat.
Tumble dry – low heat.
FIRST TIME USE
Make sure that the water tank is correctly inserted.
The dryer must be installed in a room with a temperature
ranging between 5°C and 35°C to ensure proper operation.
Before you use your dryer ensure that it has been in a upright
position for at least 6 hours.
CONTROL PANEL
1 On/Off button (hold for Reset)
2 Programme selection knob
3 Start/Pause button
Options buttons*
4 Dryness level
5 Start delay
6 Timed drying
7 Cycle end
8 Rapid (hold for Key lock)
9 FreshCare+ (hold for Mute)
*Note: some models may have the wording in full instead of the icons.
INDICATORS
Dryness level: Iron dry - Hanger dry - Cupboard dry - Extra dry
Cycle phase: Drying - Cool down - End of cycle.
Empty water tank - Clean secondary lter - Clogged door lters - Autoclean
Refer to Troubleshooting section: Failure call After-sales Service
1
3
2
9
7
8
4 56
3’’
3’’
h
1
3
2
9
7
8
4 56
h
3’’
3’’
Specyfikacje produktu
| Marka: | Whirlpool |
| Kategoria: | Suszarki do ubrań |
| Model: | FFT M11 8X3BY EE |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Whirlpool FFT M11 8X3BY EE, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Suszarki do ubrań Whirlpool
16 Stycznia 2025
12 Stycznia 2025
15 Października 2024
13 Października 2024
13 Października 2024
12 Października 2024
12 Października 2024
12 Października 2024
11 Października 2024
9 Października 2024
Instrukcje Suszarki do ubrań
- Samsung
- Altus
- GE
- Caple
- LG
- Kelvinator
- Saivod
- Electrolux
- Frigidaire
- Otsein-Hoover
- Euromaid
- Elba
- Defy
- Gorenje
- Siemens
Najnowsze instrukcje dla Suszarki do ubrań
17 Stycznia 2025
15 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
14 Stycznia 2025
13 Stycznia 2025
13 Stycznia 2025
13 Stycznia 2025
13 Stycznia 2025
13 Stycznia 2025