Instrukcja obsługi AFX Gallery GLYS140512L30D1SB
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AFX Gallery GLYS140512L30D1SB (2 stron) w kategorii Ulga. Ta instrukcja była pomocna dla 17 osób i została oceniona przez 9 użytkowników na średnio 4.8 gwiazdek
Strona 1/2
LED door Luminaires In
Wall Mount
120V / 60HzAC
Page 1 of 2 1 R2 806 181
Model #: GLYS140512L30D1SB
Model #: GLYS140512L30D1SN
Limited Factory Warranty
AFX Inc. hereby warranty that this xture is free from defects in materials and workmanship when installed and used under normal operating
conditions for a period of 5 years from date of shipment from factory. This warranty covers all component parts and extends only to replacement of
defective xture or components; it does not cover failure due to improper installation, misuse, mishandling or damage incurred in transit.
Safety Precautions
Read all safety precautions and installation instructions carefully before installing or servicing this xture. Failure to comply with these instructions could result in potentially fatal
electric shock and/or property damage.
It is recommended that a qualied electrician perform all wiring. This xture must be wired in accordance with all national and local electrical codes.
Do not handle any energized xture or attempt to energize any xture with wet hands or while standing on a wet or damp surface or in water.
This xture is designed for use in a 120VAC, 60Hz fused circuit only. This xture is compatible with a TRIAC (forward-phase or leading- -phase or trailing- edge) / ELV (reverse edge)
dimmer.
To reduce the risk of electrical shock, and to assure proper operation, this xture must be adequately grounded. To accomplish proper grounding, there must be a separate ground
wire (green) contact between this xture and the ground connection of your main power supply panel.
This xture is intended to be used for general indoor lighting in dry or damp locations.
Disclaimer
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and Canadian ICES- -005 (B). These limits are designed to 005 (B) / NMB
provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiver antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult with the dealer or an experienced radio/TV technician for help.
Any modications to this xture may void the warranty and interfere with the safe operation of the luminaire.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Assembly Instructions
Step 1 Preparing for installation–
A. at fuse or circuit breaker box before installing or Disconnect electrical power
servicing any part of this xture.
B. Carefully remove the xture from the carton, remove components from hardware kit.
C. Remove mounting plate (2) from xture.
D. Install mounting plate (2) over the junction box (not included) using two screws to (4)
secure it. For additional support, use wood screws (3) to secure to wood stud. If wood
stud is not directly behind the bracket, then drill Ø0.25 hole through the drywall to
install plastic anchors (1) for use with wood screws.
Wiring All wiring must take place inside junction box (not included) –
Caution: Make sure power is o at fuse or circuit breaker box. Check power wires for
damage or scrapes. If power supply wires are within three inches of the LED driver,
use wire suitable for at least 90°C (194°F). Most dwellings built before 1985 Note:
have supply wire rated to 60°C. Consult a qualied electrician to ensure correct
branch circuit conductor before installing.
Step 2 Wiring xture –
A. Make all wire connections to appropriate wire. Secure with wire nuts (provided).
B. Connect the green wire from the xture to the supply power source ground wire.
C. Connect the white wire from the xture to the white (N) For none-dimming xture.
wire from supply power source. Connect the black xture wire to the black (L) wire
from supply power source.
D. Connect the white wire from the xture to the white (N) wire For TRIAC dimming.
from dimming source per dimmer wiring instructions. Connect the black wire from the
xture to the black (L) wire from dimmer supply power source per dimmer wiring
instructions.
E. Pull on each wire lead to make sure connections are secure. Make Do not mix wires.
certain no bare wires are exposed outside of wire connectors. Tuck all connections
neatly into the junction bo x.
Step 3 Mounting fixture –
A. Install xture (6 over the mounting plate (2) by aligning top and bottom mounting holes to the )
plate, then use two screws (5) to secure it.
B. Install decorative glass (7) over the xture by aligning top and bottom mounting holes to the
xture, then use two screws (8) to secure it.
Step 4 Restore power at fuse or circuit breaker box. –
Specyfikacje produktu
| Marka: | AFX |
| Kategoria: | Ulga |
| Model: | Gallery GLYS140512L30D1SB |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z AFX Gallery GLYS140512L30D1SB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Ulga AFX
2 Kwietnia 2025
12 Października 2024
12 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
9 Października 2024
Instrukcje Ulga
- Aputure
- Enlite
- Prolycht
- Litecraft
- Insatech
- DCW
- Middle Atlantic
- Florabest
- SolarlampKoning
- Zuiver
- Lightway
- PowerPlus
- EnGenius
- Black & Decker
- GEV
Najnowsze instrukcje dla Ulga
9 Kwietnia 2025
8 Kwietnia 2025
8 Kwietnia 2025
8 Kwietnia 2025
8 Kwietnia 2025
7 Kwietnia 2025
5 Kwietnia 2025
5 Kwietnia 2025
5 Kwietnia 2025
5 Kwietnia 2025