Instrukcja obsługi BlendMount BRD-2017

BlendMount Niesklasyfikowane BRD-2017

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla BlendMount BRD-2017 (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 13 osób i została oceniona przez 7 użytkowników na średnio 4.9 gwiazdek

Pobierz PDF

Strona 1/2

PART# BRD-2017

Bien

llil

111111111~

I_I

1111

Innovative

Mounting

Solutions

LEFT HAND DRIVE VEHICLE

2~02

'-t

~l22

INSTALLATION INSTRUCTIONS FOR RADENSO RADAR DETECTORS

Your rear

view

mirror

has

minimal

clearance between the back side

the

mirror

and

the

mirror

stem.

very

important

that

this

mount

installed

correctly

ensure

mirror

adjustability

retained.

PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING THIS MOUNT

NOTE:

for

illustration purposes, the mount and rear view mirror shown in these instructions may look slightly different then YOUR mount

and rear view mirror.

Before installing this mount on your mirror observe how the spring clip functions. When used properly, the spring clip avoids putting excessive

pressure on the mirror when installing and removing the radar detector (RD).

release tension from the spring clip, simply squeeze the tab and

the back side

the mount together. This will lower the bottom portion

the spring clip allowing you

slide the RD on and off the mount. Push the RD

Release button and slide the RD onto the Spring Clip until you hear it lock into position, then release both the Tab and Release Button. Install and

remove the RD a few times before installing the mount on your mirror. Once the installation is complete, the spring clip allows you to access the

buttons on top

the RD while still having the RD installed to sit as close to the bottom

the rear-view mirror as possible. By gently pushing

down on the RD the spring clip is designed to flex downward allowing you to push desired buttons, then it will spring back into its original position when