Instrukcja obsługi CRUX RVCFD-79O

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CRUX RVCFD-79O (2 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 19 osób i została oceniona przez 7 użytkowników na średnio 4.7 gwiazdek

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

1 of 2

- No Dealer programming required.

- Automacally switches to Rear-view when car is in Reverse mode.

- OBD coder for single acvaon included.

PRODUCT FEATURES:

PARTS INCLUDED:

SPECIAL NOTE:

In the event this unit is to be returned for any reason, the customer must “decode” the radio before

doing so to receive a replacement or refund. See instructions below on how to decode the radio.

rev.12032021

RVCFD-79O Kit

INSTALLATION INSTRUCTIONS:

CODING THE RADIO FOR A BACKUP CAMERA

1. Locate the vehicle’s OBD II port usually located under the steering column.

2. Enter the vehicle and CLOSE ALL DOORS.

3. Turn the key to the ON posion.

4. Plug in the OBD coder from the RVCFD-79O kit to the ODB II port.

5. Wait for the OBD coder to nish coding the radio and give a solid GREEN LED. (See chart below)

6. The radio may ash a few me during this process. It can take around 5 seconds to complete the

coding process. If an error occurs, retry the coding procedure.

7. Aer the coding is complete, disconnet the OBD coder and store in a safe place. This OBD coder is

VIN specic and will only work on this vehicle.

In order for the vehicle to recognize the camera and engage it when in reverse gear, the vehicle must be

coded. Use the ODB II coder included in the RVCFD-79O kit.

DECODING THE RADIO

To decode the radio, repeat the steps above.

Specyfikacje produktu