Instrukcja obsługi CRUX SOOGM-19L

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla CRUX SOOGM-19L (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 13 osób i została oceniona przez 8 użytkowników na średnio 4.7 gwiazdek

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.071720

1 of 4

RADIO REPLACEMENT

SWC RETENTION

+

R

INTERFACING SOLUTIONS

- Retains factory features in select GM LAN V2 (LIN) Bus vehicles while functioning with an aftermarket radio.

- Retains OnStar functionality.

- Retains all chime functions.

- Retains OEM Auxiliary Input.

- Retains Factory Bluetooth in Vehicles 2008-upwards if equipped with the new OnStar device.

- Retains factory Steering Wheel Controls via built-in, preprogrammed interface.

- Retains RAP (Retained Accessory Power).

- Includes factory backup camera connection for the IO3 system. (vehicles with IO4, IO5 & IO6 systems can be hard

wired to retain the OEM camera. See page 3)

PRODUCT FEATURES:

PARTS INCLUDED:

INSTALLATION DIAGRAM:

SOOGM-19L MODULESOOGM-19L HARNESSSWC CABLEANTENNA ADAPTER

SOOGM-19L

OnStar Radio Replacement Interface with Steering Wheel

Control Retention for GM LAN v2 (LIN) Bus Vehicles 2014 - 2018

AFTERMARKET

RADIO

Reverse Red/White































TO FACTORY

HARNESS

16-Pin Green

Connector

20-Pin Gray

Connector

4-Pin

Connector

Cap or insulate if

not being used

3.5MM SWC CABLE

Plug in the 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

Audio Input

Rear Camera (IO3)

LIN BUS (Green/Black)

Antenna Adapter

(Included)

24-Pin

Connector

8-Pin

Connector

NON

BOSE

10-Pin

Connector

SWC DIP SWC

1 2 3 4

ON

Chime Volume

Adjustment

1 2 3

ON

VR Activation

for OnStar (set DIP#1 to ON)

JVC/Kenwood (Blue / Yellow)

Specyfikacje produktu